Where is the crankshaft sensor on a 2013 Nissan Altima?
The crank sensor is mounted to the back side of the engine block.
Why does my Nissan Altima shut off when put in reverse?
Hello there, many common faults will cause your 2008 Nissan Altima to shut off when put in drive or reverse. The first step in diagnosis is to check the transmission for leaks, and the fluid level and condition.
What happens when you put a car in reverse?
When car is put into reverse or drive, the engine sputters and then seizes up and dies. Check engine and oil light comes on after car engine dies. Oil recently changed.
Why does my Nissan Altima stall when put in gear?
My 2013 Nissan Altima starts but when I put it in gear it… My car has an automatic transmission. Stalling when the vehicle is put in gear simply occurs if the engine cannot accommodate the load. Among the potential causes of that are faults in engine controls.
What causes a car engine to shut off when put in drive?
Once the transmission fluid is checked most common faults are the torque converter, Idle air control valve, vacuum leaks, or a wiring harness fault. A qualified Technician such as one from YourMechanic will be able to diagnose your engine shuts off when put in drive and make any repairs required. Was this answer helpful?
Hello there, many common faults will cause your 2008 Nissan Altima to shut off when put in drive or reverse. The first step in diagnosis is to check the transmission for leaks, and the fluid level and condition.
My 2013 Nissan Altima starts but when I put it in gear it… My car has an automatic transmission. Stalling when the vehicle is put in gear simply occurs if the engine cannot accommodate the load. Among the potential causes of that are faults in engine controls.
When car is put into reverse or drive, the engine sputters and then seizes up and dies. Check engine and oil light comes on after car engine dies. Oil recently changed.
Once the transmission fluid is checked most common faults are the torque converter, Idle air control valve, vacuum leaks, or a wiring harness fault. A qualified Technician such as one from YourMechanic will be able to diagnose your engine shuts off when put in drive and make any repairs required. Was this answer helpful?