Where is the camshaft sensor on a 2003 Mazda6?
They are on the passenger side of the car by the engine mount. It can be removed with an 8mm or 5/16″ wrench. Then you just pull it straight out.
Where is the sensor on a Mazda 2?
Use the bolt in the crankshaft center to turn the engine until cylinder 1 hits Top Dead Center (TDC) on the compression stroke. You will need to align the fifth tooth to the center of the sensor magnetic tip. Check with your Mazda dealer as these instructions may vary between different 2.0, 2.3, 2.5 Mazda engine sizes.
Why is the crankshaft sensor on my Mazda not working?
Mazda cranks but won’t start. These symptoms may be intermittent in some cases. That’s why it makes it hard to diagnose a bad crankshaft position sensor, especially if the check engine light has not turned on. Follow these steps to change the crankshaft position sensor on a Mazda.
What causes a Mazda engine to not start?
A problem that may cause no-start problems on a Mazda or lead to the engine running rough is a failed crankshaft position sensor. A Mazda crankshaft position sensor (CPS) monitors the position and rotation speed of the crankshaft. Mazda cranks but won’t start.
Where is the CPS sensor on my car?
The CPS sensor is located on the same side that you have the serpentine belt. It is not on the transmission side. Remove the front wheel. Secure your vehicle with a good set of jack stands and block a tire as well, so your car doesn’t roll.
Where is the crankshaft position sensor on a Mazda?
It is held in place with several plastic clips, 8mm nut, or 10 mm nuts depending on the Mazda model. Locate the crankshaft position sensor. Unplug the electrical connector. Remove two 8mm bolts. Before you remove the old crankshaft position sensor, mark the old sensor’s exact position with a marker.
A problem that may cause no-start problems on a Mazda or lead to the engine running rough is a failed crankshaft position sensor. A Mazda crankshaft position sensor (CPS) monitors the position and rotation speed of the crankshaft. Mazda cranks but won’t start.
The CPS sensor is located on the same side that you have the serpentine belt. It is not on the transmission side. Remove the front wheel. Secure your vehicle with a good set of jack stands and block a tire as well, so your car doesn’t roll.