Where is the brake light switch on a Dodge Ram?
Dodge Ram turn signal lever. The brake light switch can wear out, which translates into no brake lights on your Dodge Ram. If the bulbs as well as the connections are good and the wires are properly grounded, replace the switch. You will find it under the brake pedal. Figure 4. Brake light switch.
Where are the turn signal relays on a Dodge Ram?
Check the flasher relay: On the driver’s side of the cabin, between the dashboard and the door, you will find a small panel covering the fuse/relay box. Refer to the inside sticker of the fuse box panel and locate the two flasher relays. Switch the relays, and check if the turn signal lights are flashing.
Where is the fuse on the brake light?
You will get the fuse panel under the dashboard and the PDC under the hood. The brake light switch is also to be found under the dashboard and check if its plunger touches the brake pedal arm. Any problem with the fuse box and light switch will affect the brake lights. In case if the fuse is blown, change it with a new one.
Why are the brake lights not working but the tail lights are?
Blown out light bulbs are the most common reason for why the brake lights not working but the tail lights are. Remove the screws from the bulb lens (which you can access through the trunk or see your vehicle repair manual to get the exact location). Push the bulbs and turn them counterclockwise to remove from the socket.
Dodge Ram turn signal lever. The brake light switch can wear out, which translates into no brake lights on your Dodge Ram. If the bulbs as well as the connections are good and the wires are properly grounded, replace the switch. You will find it under the brake pedal. Figure 4. Brake light switch.
Check the flasher relay: On the driver’s side of the cabin, between the dashboard and the door, you will find a small panel covering the fuse/relay box. Refer to the inside sticker of the fuse box panel and locate the two flasher relays. Switch the relays, and check if the turn signal lights are flashing.
You will get the fuse panel under the dashboard and the PDC under the hood. The brake light switch is also to be found under the dashboard and check if its plunger touches the brake pedal arm. Any problem with the fuse box and light switch will affect the brake lights. In case if the fuse is blown, change it with a new one.
How are the rear lights and brake lights connected?
The rear lights are controlled by the same switch as the headlights. The power flows through a relay to the rear lights when the switch is turned on. While the brake light switch is connected to the brake pedal which comes on when the pedal is pressed.