Where is the blower motor located on a 2008 Honda Accord?
2008 Honda Accord – Blower Motor The blower motor is usually located on the passenger side of the car, underneath the dash.
How to replace the blower motor assembly on a Honda Accord?
Before replacing your blower motor assembly, check the fuse to make sure it hasn’t blown out. Your owner’s manual will have information about which fuse controls the blower motor assembly.
What happens when you change the fuse on a heater blower?
If the fuse is blown, replace it and then try the blower. If the fuse blows right away, your car may have a bad blower motor or some other problem in the system. If the blower works when you change the fuse, you may not be out of the woods yet. When the motor gets old and tired it will draw more current through the wires than a new motor.
When do you need to replace the blower motor relay?
If the blower motor does not function, car fuses are blown, or relays are melting, you may have to replace the car blower motor relay. 1. Blower motor does not function 2. Blown fuses 3. Melted relay The blower motor relay is the electrical switch that is used to supply the power for the vehicle’s blower motor.
Where is the electrical connector on a blower motor?
The electrical connector is located to the left and just behind the blower motor. It is inserted straight up and is on an approximately 1½ by 3-inch flat hardboard plate. It is held in with two or four screws depending on year of vehicle you are working on. Remove the blower motor resister.
Before replacing your blower motor assembly, check the fuse to make sure it hasn’t blown out. Your owner’s manual will have information about which fuse controls the blower motor assembly.
What happens when you change the fuse on a blower?
If the blower works when you change the fuse, you may not be out of the woods yet. When the motor gets old and tired it will draw more current through the wires than a new motor.
Where is the heater duct on a Honda Accord?
The heater duct is located on the left side of the blower motor assembly. Figure 2. Remove self-taping screws holding heater duct in place. Remove the passenger’s side floor mat. Turn over the passenger’s side carpet, and pull it back as far as you can without tearing it.
When to replace a heater blower motor switch or relay?
When the motor gets old and tired it will draw more current through the wires than a new motor. It may still draw enough current to blow the fuse after it runs for a while. In that case, a motor replacement is in order. Step 1: Disconnect the battery. Put on your safety glasses and disconnect the battery at the negative cable.