Where is the ATF filter normally located?
transmission pan
The transmission filter is located above the transmission pan, which is the component that catches the excess fluid. The filter is also situated below the pickup tube, which connects to the oil pump.
How much oil does a 2006 Subaru Tribeca take?
6 quarts (with filter)After refill check oil level.
How do you check ATF level?
Pull out the dipstick, wipe it clean, replace it slowly, and then pull it back out. Check the fluid level—how high the fluid comes up on the dipstick—against the “full” and “low” or “fill” marks on the dipstick. The color of transmission fluid can tell you a lot about the health of your car’s transmission.
What kind of transmission fluid does a 2006 Subaru Impreza take?
Dexron™ VI Automatic Transmission
Subaru Impreza 2.5i Automatic Transmission 2006, Professional™ Full Synthetic Dexron™ VI Automatic Transmission Fluid by ACDelco®.
How to add transmission fluid to a 2006 Subaru B9 Tribeca?
This video shows you how to add transmission fluid to your 2006 Subaru B9 Tribeca. Before adding transmission fluid, make sure that your engine was running when you checked the fluid level. If the transmission fluid level on your B9 Tribeca is low, you need to add fluid through the dipstick tube.
How to change ATF in a Subaru Outback?
… Changing the Automatic Transmission Fluid (ATF) in the Subaru Outback 4EAT is no harder than changing the standard engine oil. No joke. AT Filter (I got mine at the dealer. While you are there pick up some of the drain plug washers if you do not already have some from changing the oil.) A socket wrench with a 17mm head.
How to add transmission fluid to a 2006 Subaru?
Add Transmission Fluid: 2006-2014 Subaru B9 Tribeca – 2006 Subaru B9 Tribeca 3.0L 6 Cyl. Follow these steps to add transmission fluid in a 2006 Subaru B9 Tribeca 3.0L 6 Cyl.. Complete video instructions to add transmission fluid to a 2006 Subaru B9 Tribeca 3.0L 6 Cyl.. When and how to check fluid level (engine should be running) About Us
How much ATF does a Subaru 4EAT Trans need?
Subaru 4eat trans requires 9.8qts ATF. That is with the torq. conv. drained…. Brucey’s method is what I do…only about half , but better than none at all. Jiffy lube or the dealer can do the full flush with a machine that cycles with a cleaner. Last I checked it was over $200…with synthetic redline ATF. OutbackwBeer!