Where is the ASR light located on an ABS?
But now the ASR light is on. So to kill that, insulate pin 29 on connector 1 of the ABS/ASR [N30/1] module by using a strong but thin tape. The MIL signal comes from this module and lights the ASR lamp located in the IC.
Why is my ASR not working in my car?
But the ASR system is tied to all of the electronic systems (EA and LH-SFI) in the car, so everything needs to be working otherwise the car is forced into the “limp-home” mode (LH). Recently, my car developed this problem and this thread is documented as it happened in a daily time format.
What is code 30 for ABS W ASR?
ABS w/ ASR Module: Code 30 – – CAN bus to EA/CC/ISC faulty. LH-SFI Module: No codes. DI Modules: No codes. I removed all of the modules in the F23 box, removed the box frame itself, and inspected all of the wiring to the connectors especially to slots 4/5 (ABS w/ ASR) and 6/7 (EA). All wiring was ‘solid’. Using an ohmmeter, the CAN bus was checked.
Is there an ASR problem on my S500?
All readings ok: 120 ohms across the bus and continuity to all modules on the bus. After re installing the modules, which had all cooled down, the car was started, NO ASR lamp. Ran perfectly. Drove it for about 20 minutes, parked it in the sun (yesterday in SD, it was 95degs).
What was the problem with the ASR on my 1992 500SL?
I started having a problem with the ASR system on a 1992 500SL. I was driving on the highway when the ASR sensor light came on and the car defaulted to a “limp home mode”: The engine output power was reduced and I was able to make almost home; after stopping at a red light the battery light came on and the car completely stalled.
Is there a problem with the ASR system?
The ASR system has a tester that the dealer can read out to get the fault code. (In addition, I’m not aware there being two motors related to the ASR system… only a hydraulic control module.) I recently purchased a 97 SL320 that had an ASR fault and the problem was a relativley cheap brake switch.
What to do if Bas ASR light is still on?
If you are still having BAS/ASR light problem, it may be time to have an auto mechanic or a Mercedes-Benz dealer in your area perform a diagnostic. If you want to figure out the BAS/ASR problem on your own, you will need to get a hold of an advanced diagnostic scanner to do a complete system scan and read the fault codes.
What does ABS Bas ASR light on Mercedes mean?
What do ABS BAS ASR lights mean? If any of these lights turns on and stay ON once you start to drive the car it means there is a problem with one of the following systems or related sensors. Step 1: Ensure that the main battery on your Mercedes-Benz is holding a proper charge. Mercedes-Benz cars are very sensitive to low voltage.