Where is the AC expansion valve located?
TXV Location The thermostatic expansion valve is usually mounted inline with the tube that supplies liquid coolant to the air conditioner evaporator. The bulb of the expansion valve is mounted to the outside of the output line of the air conditioner evaporator.
Can you clean an AC expansion valve?
Can you clean an AC expansion valve? Pretty much anything can be cleaned. But if the new part costs so little, it would not be worth the effort or risk if it was not cleaned properly.
What transmission does a 2008 Toyota Tundra have?
5-Speed Automatic Transmission
2008 Toyota Tundra, Dbl LB 4.7L V8 5-Speed Automatic Transmission (GS), Black.
Is there a cabin filter in a 2008 Toyota Tundra?
You won’t need any tools, just a new air filter. In order to gain access to the filter, you need to remove the glovebox so: Open the glovebox and locate the retaining strut on the right holding a cylindrical piece on the glovebox drawer.
Does a 2008 Toyota Tundra have a cabin filter?
2008 Toyota Tundra Cabin Air Filter.
Where is the transmission dipstick on a 2008 Toyota Tundra?
The Toyota Tundra has a maintenance-free transmission and does not have a dipstick. To check the transmission fluid level You will have to go and locate the check valve on the oil pan.
How much does it cost to replace a Toyota expansion valve?
The Toyota factory manual just recommends to blow out any debris with compressed air in there. If it is mechanically stuck, then it probably is better to go ahead and put in a new one instead of doing the same job twice. So, I think anybody can do this job for under $100 with the right tools.
How to replace the expansion valve on a refrigera?
1. DISCHARGE REFRIGERANT FROM REFRIGERA– 2. REMOVE BLOWER UNIT 3. REMOVE EVAPORATOR COVER (a) Remove 2 bolts for the liquid and suction tube. (b) Remove 8 screws and evaporator cover. the evaporator and expansion valve.
How do you remove an expansion valve from a car?
The one thing I would add is that you can remove the evaporator core/expansion valve assembly entirely from inside the car (internally there are 10 mm bolts connected to the aluminum coupler that sits in the firewall. Remove these bolts to pull the “cooling lines” away from the firewall and remove the evaporator assembly).