Where does the auto shut down relay get power?

Where does the auto shut down relay get power?

The auto shut down (ASD) relay gets power from fuse #6 (15 Amp) and fuse #15 (30 Amp) of the Power Distribution Center (PDC). The PCM activates the ASD relay and the fuel pump relay at the exact same time and thru’ the same circuit (PNK wire).

Where is the ASD relay located in the engine?

kudran, yes it can. The ASD relay is located in the Integrated Power Module (IPM), in the engine compartment. Refer to label on PDC cover for relay location. To test the relay see if this helps. When the PCM energizes the ASD and fuel pump relays, terminal 87 connects to terminal 30. This is the On position.

Why is my automatic shutdown relay making a clicking noise?

Automatic Shutdown (ASD) Relay Making A Clicking Noise (Common On Jeep) Most likely the clicking noise is because there wasn’t enough voltage going to the relays to engage them. As a result, The (ECU) was detecting a low battery condition even though it had a good battery.

How to shut down a jeep ASD relay?

1 Lost 12 volt DC electric power. 2 Sees the spark weak or dead on the ignitor drive to Ignition coil primary pin. 3 Crank sensor bad. 4 Cam sensor bad, or misfiring, CMP. 5 ASD input read back pin fails. 6 Same ASD output read back. 7 Immobilizer active.

The auto shut down (ASD) relay gets power from fuse #6 (15 Amp) and fuse #15 (30 Amp) of the Power Distribution Center (PDC). The PCM activates the ASD relay and the fuel pump relay at the exact same time and thru’ the same circuit (PNK wire).

kudran, yes it can. The ASD relay is located in the Integrated Power Module (IPM), in the engine compartment. Refer to label on PDC cover for relay location. To test the relay see if this helps. When the PCM energizes the ASD and fuel pump relays, terminal 87 connects to terminal 30. This is the On position.

Where is the ASD relay on a Chrysler Sebring?

The automatic shut down (ASD) relay turns off voltage to the primary coil on the distributor, power to the fuel injectors and turns the fuel pump off when you turn off your Chrysler Sebring so that it doesn’t sputter. The ASD relay is located in different places, depending on your model-year Chrysler,…