Where do you put the timing mark on a camshaft?
Then you align the A mark on the outer edge of the sprocket with the dot marked on the camshaft sprocket, mark to mark. You must use the corresponding marks on the crankshaft sprocket for proper installation.
Where to find alignment mark on camshaft sprocket?
The camshaft sprocket alignment mark is visible through the opening in the front distributor housing cover just above the distributor cap. When the letters “OT” are visible in the window, continue to rotate the engine clockwise until the scribe mark (line) beside the “OT” is aligned with the tab inside the window.
What’s the best way to advance the camshaft?
CAUTION: You must recheck your piston to valve clearance after advancing or retarding you camshaft timing. EXAMPLE: To advance the camshaft, you install the crankshaft sprocket using the keyway marked A. Then you align the A mark on the outer edge of the sprocket with the dot marked on the camshaft sprocket, mark to mark.
How do you advance a camshaft sprocket at Speedway Motors?
EXAMPLE: To advance the camshaft, you install the crankshaft sprocket using the keyway marked A. Then you align the A mark on the outer edge of the sprocket with the dot marked on the camshaft sprocket, mark to mark. You must use the corresponding marks on the crankshaft sprocket for proper installation. Cam Timing. Advancing.
Then you align the A mark on the outer edge of the sprocket with the dot marked on the camshaft sprocket, mark to mark. You must use the corresponding marks on the crankshaft sprocket for proper installation.
How to install a new camshaft on a camshaft?
CAMSHAFT INSTALL KA24DE INSTRUCTIONS 1. It is highly recommended that an oil and filter change be done before installing new cams. 2. Remove the plug wires, and valve cover from the en- gine. Use caution not to drop anything into the engine. 3.
Is it safe to install camshafts on evo 8?
Installing camshafts is not for the newbie unless you are absolutely sure of your ability to pull this off. Failure to install cams properly or correctly check and set timing can totally destroy your engine.
How to install a camshaft on a KA24DE?
Remove the plug wires, and valve cover from the en- gine. Use caution not to drop anything into the engine. 3. With the parking brake on, and the car out of gear (neutral), rotate the crankshaft clockwise until #1 cylin- der is at TDC (top dead center) with all of it’s valve closed.