Where do you put the alternator belt on a four cylinder car?
Many four cylinder vehicles have transverse mounted engines, meaning the engine is mounted at a ninety degree angle from the chassis, placing the belts on the side of the engine bay instead of the front. Look for cracks in the belt. A significant sign that your alternator or serpentine belt needs replacing is visible cracking along the belt.
Do you need to remove serpentine belt to change alternator?
As you loosen the bolts, the alternator will slide in the bracket under the tension of the belt. You may not need to remove the serpentine or accessory belt if it’s not damaged.
How to install stretchy belt on Chevy Silverado?
Install EN-51767-2 – Universal Stretchy Belt Installer (1) onto the balancer. (Image 2) Position the belt (2) on the balancer as shown. Slowly rotate the crankshaft in a clockwise direction until the belt (2) fully seats on all pulleys. (Image 3)
How to remove serpentine belt from Chevy Silverado 5.3?
Remove the belt from the generator pulley. Install EN-51767-2 – Universal Stretchy Belt Installer (1) onto the balancer. (Image 2) Position the belt (2) on the balancer as shown. Slowly rotate the crankshaft in a clockwise direction until the belt (2) fully seats on all pulleys.
Install EN-51767-2 – Universal Stretchy Belt Installer (1) onto the balancer. (Image 2) Position the belt (2) on the balancer as shown. Slowly rotate the crankshaft in a clockwise direction until the belt (2) fully seats on all pulleys. (Image 3)
How do you replace a / C belt tensioner on a Chevy Silverado?
Rotate the tensioner clockwise against the spring, and hold it. Then slip the belt off the tensioner pulley. Release the tensioner slowly back to the spring stop. Slip the belt off the crank pulley and let it hang. Figure 4. Accessory drive belt removal. Examine the belt for cracked ribs or fraying, and consider replacing it.
How do you tighten a serpentine belt on a car?
If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt. Tighten the bolts again as you apply tension.
How do you remove an alternator from a car?
If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt.
What happens if you put the wrong belt on your alternator?
Different vehicles have different sized belts and installing the wrong size could result in failing to power the accessories or even damage to the engine. If your old belt was loose because it had stretched over time, take that into consideration when comparing the two belts.
How to find the right parts for a Mercury MerCruiser?
Find the right parts for your Mercury® or MerCruiser® engine here. Search by serial number to see detailed engine diagrams and part numbers, then contact your local authorized Mercury Marine dealer to place your order. You can also browse by model, but we strongly recommend using your serial number to ensure you find the correct parts.
How do you check the tension on an alternator belt?
Check the belt tension. Once you have released the auto-tensioner or tightened the alternator bolts, check the tension of the belt to make sure it has seated properly on all pulleys. Pinch the belt between your thumb and index finger and try to wiggle it. There should be very little give to a properly installed alternator or serpentine belt.