Where do you jack up a Honda?
Park the car on a level surface. Place a pair of wheel chocks behind the rear wheels to prevent the car from rolling backwards. Look for the front jack point, and place your jack underneath it. While there are other suitable places you can use, this is by far the best and strongest jack point.
How do you change the battery in a Honda?
Some Honda models may have a second bracket that surrounds the battery. If this applies, then slide the bracket out and free up the battery. Lastly, firmly grab the battery and pull it straight out. Figure 7. Make sure to get a good grip to pull the old battery out. Gloves are recommended. Figure 8.
Can a Honda Civic del Sol battery be replaced?
Fixing it could be as simple as swapping the battery. This article applies to the Honda Accord (1990-2002), and Civic Del Sol (1992-2000). Even though batteries are a simple component, they’re one of the key items required for a car to run. The more you know about them, the less chance there is of a dead battery leaving you stranded.
How do I Reset my Honda Accord immobilizer?
Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display.
What do I need to do to reset my car battery?
Program any radio or security codes following the manufacturer’s directions. Follow the steps for any drivability learn procedures necessary on your year and model. Many vehicles will go through these procedures automatically if you drive for 10 to 20 minutes.
How to reset my Honda radio after putting in a new battery?
Step 1 Turn the ignition key to the “On” position, but don’t start the engine. Turn the radio on by pressing in on the volume control knob. After 10 seconds, turn the radio off. Press and hold the power button for two to five seconds and watch the radio display. Release the power button when the display lights up and the radio turns on.
How do you remove the battery from a Honda rancher?
Step 1 Park your Honda Rancher on a flat surface with plenty of room to work comfortably. Locate the hand switch that opens the seat. Pull the seat up and off of the Honda Rancher. Remove the battery mounts using the Phillips head screwdriver.
How do you replace a battery in a car?
Push the mounts aside and pull the battery out of the housing. Place the new battery into the battery housing, reconnect the mounts and tighten the mounts using the Phillips head screwdriver, reconnect the battery wire and tighten the securing screw using the Phillips head screwdriver, and replace the seat, snapping it into place.
How do you remove a battery from a Phillips head?
Pull the wires up and off of the battery. Remove the battery mounts using the Phillips head screwdriver. Unscrew the screws on the mounts on the left and right side of the battery. Push the mounts aside and pull the battery out of the housing.