Where do the timing marks go on a cam belt?
Do not worry about timing the distributor, since it has an offset drive dog and should therefore fit only one way – unless you have taken the drive dog off the distributor and turned it 180-degrees by mistake. In which case, with the engine at the timing marks, the rotor arm should be pointing towards the arrow on the dust shield:
Where is the timing mark on the oil pump?
After re-setting the timing the engine refuses to start and sound as if there is no compression when turning over, any ideas, also can anyone tell me the exact location of the mark on the oil pump casing for the crankshaft pulley to line up with, i do not seem to be able to find one. (maybe i need stronger glasses?)
Where to find timing marks on a fire engine?
Timing marks on the FIRE – I use the flywheel marks on the gearbox bellhousing. Turn the engine slowly and look for a long square notch in the flywheel to align with the leftmost mark as you look at the gearbox window:
Where are the timing marks on a Harley Davidson?
Locate the proper timing marks for your engine. If the shop manual is not available, remove spark plugs, turn engine until front piston is at TDC on compression stroke and identify TDC mark on the flywheel. 2. Connect leads of INDUCTIVE TIMING LIGHT to front spark plug cable, to battery positive terminal and to ground. 3.
What’s the timing range on a Harley Davidson Sportster?
Sportster: Timing Range: 0-35 : 0-45: Timing at Start: 5 : Timing at adjust RPM: 35 : Adjust RPM: 1500: 1650-1950
Where are the timing marks on a Suzuki engine?
Timing. On most Kawasaki and Suzuki engines the marks are lines on the cam sparockets and should be even with the top edge of the cylinder head. There is one extra thing on Kawasakis and Suzukis. Count the number of cam chain rollers from the exhaust timing mark to the intake timing mark.
How to check the timing on a 1978 Shovelhead?
I want to check the timing on my 1978 shovel (FXE)… without using a timing light. Can anyone point me in the direction of the best directions to do this? The front cylinder advance mark is a vertical line and the front TDC mark is a shallow drilled hole just less than 1/8″ diameter.