Where can I get help troubleshooting my Thermo King?
If you need help further troubleshooting your Thermo King unit, visit the Mobile Reefer Repair in Sacramento,CA. Information for this article was sourced from Transport Refrigeration website.
How does Thermo King fit into the supply chain?
Joined by several state and local leaders, Thermo King shared with the group how their high-quality HVAC systems fit into the public transit supply chain.
Where are Thermo King refrigeration systems located?
Systems had to become more energy efficient for power management and conservation. Just before the end of 2018, Transportation for America traveled to Thermo King’s headquarters in Bloomington, MN to get an up close look at the economic impact of public transportation dollars on Minnesota’s manufacturing jobs.
Is the Thermo King Air purification system effective?
Thermo King Launches Air Purification System for Public Buses: 98% Effective in Deactivating Surrogate for Virus That Causes COVID-19 Friday, April 16, 2021 This solution helps Americans return to work with safer and healthier public commutes.
What makes a Thermo King diesel refrigeration unit so good?
A complete line of self-powered diesel truck units that deliver lower cost of ownership through lower maintenance costs, improved fuel economy and unmatched reliability. The cornerstone of all Thermo King refrigeration units is reliability, and the T-90 Series continues the tradition.
What is the alarm code for a Thermo King truck?
Thermo King Alarm Codes – North America. This is a listing of all current truck, trailer, CR, DAS and DSR alarm codes. On multi-temp units, the zone will be identified. Please record all alarms that occur to assist technician in resolving issue. Alarm codes with parenthesis (XX) may exist with alarm code 84 and may clear automatically.
What does TK monitor do on Thermo King TriPac?
Discussion:Thermo King TriPac EVOLUTION units have TK Monitor communication software built into the Base Controller of each unit. It allowed PC type computers to establish two way communications with the EVOLUTION control system without special software being loaded on the computer.
What happens if you jump start a Thermo King?
Jump the starter and observe the battery voltage. If the starter fails to engage and the voltage falls to 1V or 0V, then you have a bad battery. Replace the battery. Warning: Any attempt to jump start the battery may cause it to explode. Check for a defective high-pressure cutout (HPCO) switch.
Where is the fuel solenoid on a Thermo King?
The fuel solenoid is located on the back of the injection pump. Turn the unit on and keep a finger on the solenoid. The unit will buzz, indicating a startup. The fuel solenoid will clunk, and the starter will engage. If the solenoid clunks, then it has energized and is okay.
Where is the HPCO switch on a Thermo King?
Check for a defective high-pressure cutout (HPCO) switch. The HPCO is located on the top of the compressor. Disconnect the harness and bypass the HPCO switch. If the unit starts, then the HPCO switch is defective. Check the wiring harness on the 8D circuit. If the unit still won’t start, then verify voltage to the HPCO switch.