Where can I get an oxygen sensor tool?
This tool covers a wide variety of options and fits most heated and non-heated sensors. Designed to be used on oxygen sensors on modern vehicles and its cut out socket enables it to fit over wiring harnesses. This unit also features a 1/2” drive offset at 50mm high. Limited stock, please call 0115 956 5555 for availability.
What kind of wrench do I need for an oxygen sensor?
This offset oxygen sensor wrench enables you to remove and install sensors on computerized engine controlled vehicles. The offset design helps you reach oxygen sensors in tough-to-reach spots compared to standard wrenches. Features include chrome molybdenum construction and a six-point socket with cutaway for wire clearance.
What is the socket for an oxygen sensor?
The Draper LSS7 Oxygen Sensor Socket Set is designed for the removal, inspection or replacement of heated and non-heated oxygen sensors fitted to the following vehicle marques; Audi, BMW, Citroën, Mercedes,… The Laser Oxygen Sensor Socket has been designed with a window in the socket which allows the wires to sensors to be bypassed.
What kind of thread Chaser for oxygen sensor?
Designed to be used on oxygen sensors on modern vehicles with a cut out on socket enables socket to fit over wiring harnesses.Thread chasers are: M12 x 1.25, M18 x 1.5mm3/8″ Drive: Straight 80mm deep 22mm,…
This offset oxygen sensor wrench enables you to remove and install sensors on computerized engine controlled vehicles. The offset design helps you reach oxygen sensors in tough-to-reach spots compared to standard wrenches. Features include chrome molybdenum construction and a six-point socket with cutaway for wire clearance.
Can a deep socket be used for an oxygen sensor?
Sure, your deep socket will fit, but even once you clip the wires and remove the old unit, how in the world are you supposed to install a new one? Enter the oxygen sensor socket. With a purpose-built slot to accommodate the wiring harness, this tool can be an absolute lifesaver for any oxygen sensor installation job.
What’s the best way to remove an oxygen sensor?
Unscrew the oxygen sensor off the exhaust pipe using either an open-end wrench or a special socket made to remove it. The majority of oxygen sensors will take an SAE 7⁄8 inch (2.2 cm) wrench.
How big is an offset O2 sensor socket?
For the mechanic who can’t quite reach a particular O2 sensor, the Ares 3/8-Inch Offset Oxygen Sensor Socket can save the day. For the mechanic who can’t quite reach a particular O2 sensor, the Ares 3/8-Inch Offset Oxygen Sensor Socket can save the day.