Where can I get a new swing arm for my Harley?
1. Go on e-Bay, a local Trike manufacturer who converts Harleys & get either a 2002-2006 or better still a 2007 FL swingarm take-off. This way you start off with a new, undamaged item. Get the 1” axle with the unit. These Trike people are happy to get rid of the take-off stuff. 2.
Can you use a 2001 rear wheel in a 2002 FXR?
The 2002 & up rear axle is not interchangeable with the ¾” axle used in earlier models. A 1” wheel bearing can not be put in a 2001 or earlier wheel as you can get bearings to fit but a wheel spacer must be used between the bearings and the 2001 & earlier model wheel will accommodate this spacer.
Why does my FXR rear swing arm feel twitchy?
Cleve Blocks which are nothing but rubber bushings prone to not stay ridged during side loading of the rear fork due to lateral forces during turning. This is why your bike feels “twitchy” and unstable during cornering. 3. In 2002 a ¾” pivot bolt was substituted for the 5/8” pivot bolt.
How much does a 2007 swing arm cost?
• In the caseof a 2007 swingarm; buy and do not pay over $40 for the swing arm and axle. You must use the corresponding axle as a ¾” axle set-up is different (along with wheel bearings & spacers).
When did Harley Davidson upgrade their swingarms?
In 2002 Harley upgraded the swingarm by making a new swingarm that is more ridged and stronger. Here are some of the differences: 1. The swingarm had been strengthened in the areas shown above in 2002. The 2007 has undergone another change not covered here.
The 2002 & up rear axle is not interchangeable with the ¾” axle used in earlier models. A 1” wheel bearing can not be put in a 2001 or earlier wheel as you can get bearings to fit but a wheel spacer must be used between the bearings and the 2001 & earlier model wheel will accommodate this spacer.
Cleve Blocks which are nothing but rubber bushings prone to not stay ridged during side loading of the rear fork due to lateral forces during turning. This is why your bike feels “twitchy” and unstable during cornering. 3. In 2002 a ¾” pivot bolt was substituted for the 5/8” pivot bolt.
What kind of swing arm do I need for a Harley?
Go on e-Bay, a local Trike manufacturer who converts Harleys & get either a 2002-2006 or better still a 2007 FL swingarm take-off. This way you start off with a new, undamaged item. Get the 1” axle with the unit. These Trike people are happy to get rid of the take-off stuff.