Where are the nuts located on a Subaru Outback?
Remove the two lower nuts connecting the right and left front mounts to the car’s subframe on the right side using a ratchet wrench. The forward stud and nut are usually accessible through the bottom of the subframe, while the rear bolt is on the bottom of a bracket.
How do you remove a transmission mount on a Taurus?
Rotate the bracket counterclockwise to detach it from the upper stud and remove the mount. Position the rear/transmission mount on the car’s subframe and attach the support bracket to transmission, tightening the nuts and bolts with the wrench. Connect the mount to the subframe bracket with its two through-bolts.
Where is the air conditioner mount on a Ford Taurus?
Unscrew the two bolts connecting the left-hand forward mount to the air conditioner compressor bracket using the wrench–you should be able to reach the bolts through the right fender well–and remove the left forward mount.
Remove the two lower nuts connecting the right and left front mounts to the car’s subframe on the right side using a ratchet wrench. The forward stud and nut are usually accessible through the bottom of the subframe, while the rear bolt is on the bottom of a bracket.
How to install a lower strut on a car?
TWO LOWER BOLTS STYLE: • (Fig. 4) Remove and save lower mounting nuts (G) and bolts (H). Separate lower strut mount from steering knuckle. • (Fig. 1) Remove and save the bearing plate upper mounting nuts (A). (P-Pack included with new nuts.) • Remove the strut assembly from vehicle (Fig. 5, 6 & 7).
How do you remove studs from a shock mount?
When you get the nuts off a stud mounting, you still have to pry off the shock, working evenly at top and bottom so it doesn’t cock. If you’re not sure of the condition of a bone-dry shock, just disconnect it from the bottom mount if possible (or remove it completely if it’s on studs).
How to install a torque nut on a strut?
• Install tie rod end to strut (Fig. 4) and torque nut (J) to the value shown in the original equipment service manual. • If vehicle is equipped with stabilizer bracket, install stabilizer link to strut and torque bolt to the value shown in the original equipment service manual. • Install brake hose and ABS brackets to strut, if so equipped.