Where are the fuses on a Golf Jetta?
Golf/Jetta IV Fuse List Fuse Amps FuseLocation Power Source/Circuit Description Notes Fuse Panel Engine Comp. Relay Panel Battery Battery Relay Panel Ignition Switch Light Switches S1 10 1 75x Washer nozzle heaters, glove compartment light, memory seat control module S2
What to do if your Jetta fuel pump goes out?
Matthew Wright has been a freelance writer and editor for over 10 years and an automotive repair professional for three decades specializing in European vintage vehicles. Use this diagram to determine which fuse to replace if your brake lights or fuel pump go out in your 1999 or newer Volkswagen Jetta or Golf.
What kind of electrical system does Volkswagen Jetta have?
Vehicle electrical system control module, 16-pin connector, (diagnostic connector) Light switch, Rain/light recognition sensor, Compass magnetic field sensor Steering column electronics control module, Data bus on board diagnostic interface, Signal horn activation
What is the ignition switch on a Volkswagen Jetta?
Ignition/starter switch, Tiptronic switch, Automatic transmission control module, Selector lever sensor system control module, Climatronic control unit, Auxiliary engine coolant heater radio frequency receiver
What is the relay code for a VW Jetta?
Relay code number 100 is replaced by relay code number 370 depending on production. N… – Ignition coils 1-4 with output stage (up to May 2005) N… – Ignition coils 1-4 with output stage (up to May 2005) N… – Injectors cylinders 1-4 (up to May 2005) N… – Injectors (up to May 2005)
Where are the fuses on a new beetle?
Location Volkswagen New Beetle – fuse box diagram – location Fuses -S162-, -S163-, -S164-, -S176-, -S177-, -S178-, -S179-, -S180- on fuse holder/battery Fuses -S43-, -S111-, -S130-, -S144-, -S283-, -S329-, -S337-, -S338-, on the 13 position additional relay carrier above the relay plate Fuses (S) in fuse holder, left dash panel
How to check the wiring of a VW Jetta?
Using the test box V.A.G 1598/18 the wiring can be checked according to the wiring diagram. NOTE: – Before connecting test leads the correct measuring range on the tester must be adjusted. Otherwise the electronic components can be destroyed! – Use the multimeter V.A.G 1526 with auxiliary cables from V.A.G 1594 for testing.
How to turn on ignition on Volkswagen Jetta?
Switch ignition on and select engine control module with “Address word” 01. (Connecting scan tool and selecting engine control module).
Where to insert switch 2 in VW Jetta?
– Insert switch -2- (or switch -3-) into vent and engage. fPage 174 f- Place sufficient lint-free cloths under the ABS control module and hydraulic unit – fRemove brake lines -3- on the side of hydraulic unit CAUTION: DO NOT BEND BRAKE LINES IN THE AREA OF THE HYDRAULIC UNIT.
How do you fix a VW Jetta horn?
For this step, connect a jumper wire to a good ground on your Jetta. Have a helper press the horn while you make contact with the horn using the other end of the jumper wire. If the horn starts to work at this point, fix the ground connection so the horn makes good contact with the chassis.
What are the injectors on a VW Jetta?
– Injectors (up to May 2005) WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.