Where are the brake lines on a car?
Look how the car is built: On some cars, the front and rear suspensions are on subframes. In most cases, the brake lines installed on the unibody and the subframes are attached. This can create problems if the brake or fuel lines need to be replaced.
How to replace rear brake lines and hoses with Kit?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: emdMb2XstNr_1_BB)
How to check the brake line on a Nissan?
Enter your VIN for the most accurate results. We offer a full selection of genuine Nissan Brake Lines, engineered specifically to restore factory performance. Please narrow the Brake Line results by selecting the vehicle.
What kind of valve do you need for a disc brake?
This diagram shows a typical street rod brake system. A 2 PSI residual pressure valve (RPV) is needed in the disc brake circuit, and a 10 PSI RPV is required in the drum brake circuit as well as an adjustable proportioning valve (APV). This diagram illustrates the 2 most common types of fittings used in street rod brake systems.
What are the parts of the brake system?
We have included both the components of the disc and drum brake systems. Most modern vehicles have disc brakes on all four corners, but some economy cars still use drum brakes in the rear. The brake master cylinder pushes hydraulic fluid down into the brake lines from the brake fluid reservoir.
What kind of brake lines do I Need?
The car in the drawing has a single-chamber master cylinder with drum brakes front and rear. It only needs one residual pressure valve (10-lb) and a proportioning valve for the rear brakes. Lines are 3/16-inch, 45° double-flared with -3 AN braided hoses in place of the original rubber type hoses.
Where is the brake line located on a Ford?
The line connects with a 3/16-inch flare nut on the 45° flared line. Early Ford style multi-port fitting at the rear of the master cylinder provides a mounting point for the brake switch. This adjustable proportioning valve is mounted in the line going to the rear brakes.
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: emdMb2XstNr_1_BB)