When to replace sunroof in Series III XJ6?
YOU MAY WANT TO WAIT UNTIL YOU HAVE MADE ALL ADJUSTMENTS BEFORE REASSEMBLING THE DRIVE ASSEMBLY AND REPLACING THE SEAT. If step two doesn’t allow it to close all the way he may have moved the position of the rack stop on reinstallation.
How can I Fix my headliner without removing it?
To fix headliner in car without removing, you have to apply a special headlining adhesive because the ordinary glue will be of no use. A spray can adhesive is likely to be the best solution to apply and distribute the glue evenly. 2. Pin It Down. It’s another quick fix that won’t require much time and money.
Why does my car’s headliner keep getting loose?
It gives the car’s roof a smooth texture, absorbs noises, and keep a pleasing interior temperature by buffering the outside cold and heat. Over time and due to extreme weather conditions, the fabric may become loose and get separated from its backing board.
YOU MAY WANT TO WAIT UNTIL YOU HAVE MADE ALL ADJUSTMENTS BEFORE REASSEMBLING THE DRIVE ASSEMBLY AND REPLACING THE SEAT. If step two doesn’t allow it to close all the way he may have moved the position of the rack stop on reinstallation.
How to fix a leak in the sunroof?
While the black plastic wedges are off. On the underside there should be a set screw which can be turned counter clockwise to raise the roof or clockwise to lower. Adjust each side as necessary and replace the wedges and test.Re-do as necessary to get each side even and at the proper height.
How to adjust the height of the sunroof?
Sunroof height adjustment 1 While the black plastic wedges are off. 2 Adjust each side as necessary and replace the wedges and test.Re-do as necessary to get each side even and at the proper height. 3 Again use small increments as you don’t want to bind the roof or raise it high enough to scratch the paint.
Where is the wedge on the sunroof?
SEE BELOW. Open the sunroof all the way. This exposes a black plastic wedge about 1 1/2 inches long on the edge track of the sunroof on each side (viewed from the top). This wedge controls the position and lift (height) of the sunroof as it closes.
Which is standard equipment on a Jaguar XJ6?
Power-assisted Anti-lock Brake Systems (ABS) with four-wheel disc brakes are standard equipment on all Jaguar XJ6 models covered in this manual. Power rack-and-pinion steering is also standard equipment. Your Jaguar manual The aim of this manual is to help you get the best value from your vehicle. It can do so in several ways.
Where is the transmission on a Jaguar XJ6?
Transmissions are a four-speed automatic equipped with a lock-up torque converter. The transmission is mounted to the back of the engine, and power is transmitted to the fully independent rear axle through a two-piece propshaft.
SEE BELOW. Open the sunroof all the way. This exposes a black plastic wedge about 1 1/2 inches long on the edge track of the sunroof on each side (viewed from the top). This wedge controls the position and lift (height) of the sunroof as it closes.
How do you remove the sunroof on a Jaguar?
(From memory): Open the sunroof about 9 inches. Then remove the three screws on the front edge of the roof. Close the roof to within about 1 inch of closed, then lift the leading edge of the panel while gently pulling forward. It should slide right out.
What kind of transmission does a Jaguar XJ6 have?
Jaguar XJ6 Service and Repair Manual 3261 Jaguar XJ6 Models covered Jaguar XJ6 models with 3.2 litre (3239 cc), 3.6 litre (3590 cc) & 4.0 litre (3980 cc) six-cylinder in-line dohc petrol engines and automatic transmission
Where is the locknut on a Jaguar sunroof?
On the outside of the gearbox housing at the top of the worm gear is a threaded screw and locknut that controls the backlash of the worm gear. On mine, the locknut and screw had backed out over time, and when you ran the motor in the “close” direction, the worm gear would move too far and jam in the sector gear.