When does the Mazda i-stop light turn off?
Depending on the model and location of your Mazda, the green i-stop light illuminates either when the engine has been stopped and turns off when the engine is restarted, or illuminates when engine idling stop conditions are met while the vehicle is being driven.
Why does my Mazda 3 stall at stops?
Something similar happened to me with my 2004 Mazda 3. At the end, the problem was the fuel pump. After disconnecting the battery to jump start another car, my car’s PCM could never re-learn how to control the engine because the fuel pressure was way below specifications.
How can I tell if my Mazda 626 is running?
You can use a noid light, available at parts stores, to see if the electrical circuit is working. You can also measure the resistance of the injectors. The resistance should be approximately 13.8 ohms at 68 F. Other possibilities: Weak fuel pressure. You can check this with a fuel pressure gauge.
Why does my car stall at a stoplight?
Rough Idle in the Cold It’s a cold day and you’re stopped at a stoplight. You take your foot off the gas pedal to apply the brake, but your engine begins to idle very roughly, and then it stalls. Yet, when you restart the engine and run the car at higher speeds, it seems to run fine, or at least more smoothly.
Something similar happened to me with my 2004 Mazda 3. At the end, the problem was the fuel pump. After disconnecting the battery to jump start another car, my car’s PCM could never re-learn how to control the engine because the fuel pressure was way below specifications.
What causes a car to stall at a stop sign?
In vehicles with automatic transmissions that sometimes have a problem with stalling at lights or stop signs, most of the time it is a difference in pressure on each side of the pressure plate. A loss of pressure on one side or another will cause a stall.
What to do when your engine stalls at a stop?
Start the vehicle and let idle until engine is warm, and then shut it back off. Wait 10-15 minutes then start the vehicle, let idle until warm & then shut back off.
What should I do if my car stalls at an intersection?
If you have to check the fluid with the car running, make sure to set the parking brake. Most cars will ask you to put the car in Park or Neutral. Make sure you do not have the car in gear. The car may be just idling too low which can be adjusted very easily with a screwdriver if you drive an older car.
When is I stop inhibited on a Mazda 2?
The following instances where i-stop is inhibited applies to all versions of Mazda that have i-stop technology including the Mazda 2, Mazda 3, Mazda 6, CX-3, CX-5 and MX-5. This is where your vehicle has come to a complete standstill but the engine is kept idling.
Depending on the model and location of your Mazda, the green i-stop light illuminates either when the engine has been stopped and turns off when the engine is restarted, or illuminates when engine idling stop conditions are met while the vehicle is being driven.
The following instances where i-stop is inhibited applies to all versions of Mazda that have i-stop technology including the Mazda 2, Mazda 3, Mazda 6, CX-3, CX-5 and MX-5. This is where your vehicle has come to a complete standstill but the engine is kept idling.
Why does my Mazda engine stop not work?
Engine stop does not take place when Mazda diesel versions are undergoing particulate matter removal from the filter (DPF regeneration). Brake booster vacuum pressure reserve is too low.
How to fix a Mazda that stalls at stop?
Remove the air hose from the throttle body. Disconnect the throttle body connector. Remove the throttle body from the intake manifold, with the water hose connected. Clean the throttle body on the air hose side using a soft, clean shop cloth, sprayed with engine cleaner (Mazda recommends their P/N 000-77-A86).