When do I need to Reset my Saturn Vue?
The Oil Change Light Reset Saturn VUE 2008 2009 will need to be performed after every oil change. If it is not reset the system will be unable to properly track when your next oil change is due. Below is the procedure for the Saturn VUE 2008 2009 .
How to turn off Saturn Vue oil life light?
To turning off the Oil Life Light on 2004, 2005, 2006, 2007, 2008, 2009, 2010 Saturn Vue, conform to the following instructions: Turn the ignition key to position “ON” without starting the engine Note: Repeat the process, if message illuminates when you start the engine.
How do you reset the gas pedal on a Saturn Vue?
Press and release the gas pedal three times within five seconds on Saturn Vue and late model L-Series vehicles. The display light will flash a few times to indicate that it has been reset. Start the vehicle. If the procedure was done correctly, the oil indicator will either be at 100 percent or the light will have disappeared.
Where is the oil life meter reset button on a Saturn?
You need to manually reset the oil life meter. Saturn models from 1991 through 2003 feature a reset button located within the fuse box in the engine compartment. Saturn models from 2003 on need to be reset manually by using the trip/reset button located on the face of the display. No tools are required to complete this simple task.
The Oil Change Light Reset Saturn VUE 2008 2009 will need to be performed after every oil change. If it is not reset the system will be unable to properly track when your next oil change is due. Below is the procedure for the Saturn VUE 2008 2009 .
To turning off the Oil Life Light on 2004, 2005, 2006, 2007, 2008, 2009, 2010 Saturn Vue, conform to the following instructions: Turn the ignition key to position “ON” without starting the engine Note: Repeat the process, if message illuminates when you start the engine.
How to reset the oil life monitor after an oil change?
Follow the steps below to reset the oil life monitor after each oil change. Turn the ignition to the “RUN” position. Immediately press and release the accelerator pedal 3 times within 5 seconds. If “CHANGE ENGINE OIL” light is flashing, the system is reset. Turn the ignition off.
What should I do if my oil change light is flashing?
Turn the ignition to the “RUN” position. Immediately press and release the accelerator pedal 3 times within 5 seconds. If “CHANGE ENGINE OIL” light is flashing, the system is reset. Turn the ignition off. The 3.5 liter engine holds approximately 4 quarts (3.8 liters) of 5W-30 oil when the engine oil and filter are changed.