What year is Xlx?
Harley Davidson XLX 1000-61 Sportster
| Make Model | Harley Davidson XLX 1000-61 Sportster |
|---|---|
| Year | 1982 – 85 |
| Engine | Four stroke, 45° V-Twin, OHV, 2 valves per cylinder |
| Capacity | 998 cc / 60.8 cu-in |
| Bore x Stroke | 81 x 96.8 mm |
What should the electrical reading be on a Harley Davidson Sportster?
A normal reading is between 140 to 180 amps. A lower reading indicates a low battery charge or a starter with a internal electrical problem. A higher reading indicates a mechanical problem with the engine, starter, or high resistance in the starter to battery wiring/starter ground wire.
Why is my Harley Davidson Sportster not starting?
Place your Sportster in second or third gear for the best results. A battery that can’t start your engine may no longer be recharging properly because of its age and current state of charge. The ground cables that connect the battery to your Sportster frame must also be undamaged and free of corrosion.
What are the symptoms of a bad starter relay?
Listed below are a few of the symptoms of a damaged or worn out starter relay. If you notice these warning signs, make sure you contact a local ASE certified mechanic to completely inspect your vehicle as these symptoms might indicate problems with other components. 1. Vehicle does not start
What to do if your Sportster is not getting spark?
Open your gas cap and listen for a possible vapor lock condition. Ground your spark plugs to check for spark. If this problem began after you cleaned your carb, start looking in that area 1st.
How to check the charging system on a Harley Davidson Sportster?
To check your charging system: Start the engine and record the battery voltage on your multimeter. The voltage should be near 14 volts. Raise the engine RPM’s to 2,000 and turn on all your Sportster’s electrical accessories, such as lights, radio, etc.
Place your Sportster in second or third gear for the best results. A battery that can’t start your engine may no longer be recharging properly because of its age and current state of charge. The ground cables that connect the battery to your Sportster frame must also be undamaged and free of corrosion.
What should the Run switch read on a Harley Davidson Sportster?
Remove the kill switch from the right handlebar grip. Measure the resistance/continuity of the switch with the switch unpressed using the same method described for testing the run switch. The reading should be 0.1 ohms or less. Press the switch and measure again. The reading should now be “OL” or infinite, meaning no connection is present.
Where is the starter on a Harley Davidson 883 Sportster?
Connect your red probe to the solenoid positive wire. This is a fat 12 or 14 gauge wire on the cylindrical portion of the starter. Connect the black probe to a known good ground. 12v should be present in this wire at all times. Figure 3. The starter location on a 883 Sportster.