What was the problem with my Nissan 85?
I rebuilt the carburator in the 85 4×4 and repaired the rounded plug connector. Still engine did not want to idle it would run erratically and died. Then I proceeded to check the electrical circuit.
Are there any problems with the Nissan 720?
Dwayne Oxford on February 28, 2019: See no way to reply to questions/posts here, but those of you having probs with Nissan 720’s need to be at 720 World. Tim on February 04, 2019: bcstoy – carburation part II on January 22, 2019: I rebuilt the carburator in the 85 4×4 and repaired the rounded plug connector.
What should I do if my Nissan starter is not working?
Charge the battery until it reads at least 12 volts of power on the multimeter, and then attempt to start the Nissan. Turn on the headlights on your Nissan, and attempt to start the vehicle. If the headlights do not dim, the ignition relay switch is defective.
What causes a Nissan Leaf not to start?
The starter system in a Nissan consists of the battery, ignition relay switch, starter motor and starter solenoid. If one of these components fails, you Nissan will not start. Fortunately, you can isolate and troubleshoot each component to quickly determine which component is causing your Nissan not to start properly.
I rebuilt the carburator in the 85 4×4 and repaired the rounded plug connector. Still engine did not want to idle it would run erratically and died. Then I proceeded to check the electrical circuit.
Dwayne Oxford on February 28, 2019: See no way to reply to questions/posts here, but those of you having probs with Nissan 720’s need to be at 720 World. Tim on February 04, 2019: bcstoy – carburation part II on January 22, 2019: I rebuilt the carburator in the 85 4×4 and repaired the rounded plug connector.
What kind of fuel pump does a Nissan 720 have?
Dan has been an auto mechanic, truck driver, engineer, and many other things. This article is for owners of the 1981–1985 Datsun or Nissan 720 pickups with the electric fuel pump. On this page, you will learn how to go beyond the typical service manual fuel delivery problem diagnosis.
How to troubleshoot a Nissan 2.4L no start?
Broken timing belt. 1 Blown head gasket. 2 Blown engine. 3 Broken timing belt.
What should the idle RPM be for a cold engine?
Another thing to consider is that when you first start a cold engine, the computer increases the idle rpm to maybe 1200 instead of 800 for a warm engine, and enriches the fuel mixture a lot compared to a warm engine. Then in a minute or two as the coolant warms, the computer begins to drop the idle rpm and lean out the mixture.
Is the fuel pump on my Nissan 1400 1985 working?
Clide Tshuma on October 16, 2019: I’m sitting here with my nissan 1400 1985 model is not pumping fuel to curburater but when you fill 2 litter bottle with petrol it drives well I need your help Dwayne Oxford on February 28, 2019:
How long does a Nissan fuel pump relay last?
A factory relay is labeled Jideco, and if you choose to replace it, they seem to last about 20 years. On the back of the assembly are four Phillips screws. Once removed, the cover and insulator come off and you’re looking at the circuit board of the relay itself.
Clide Tshuma on October 16, 2019: I’m sitting here with my nissan 1400 1985 model is not pumping fuel to curburater but when you fill 2 litter bottle with petrol it drives well I need your help Dwayne Oxford on February 28, 2019:
Why does my Datsun pickup truck not idle?
If any of these tests fail then the truck will not idle because they actually control the idle stop solenoid. To check the idle stop solenoid you should turn the key on and check for power at the red wire for the solenoid. Or if powered directly from the battery you should hear it clicking.
If any of these tests fail then the truck will not idle because they actually control the idle stop solenoid. To check the idle stop solenoid you should turn the key on and check for power at the red wire for the solenoid. Or if powered directly from the battery you should hear it clicking.
What’s the name of the Nissan Datsun Truck?
You might know the more common Datsun 1200 cars, but for a while Nissan made a truck version of the B110 Datsun 1200, called internally the B120. In Japan it was called the Datsun Sunny Truck. While not horribly common in the United States, this truck was sold in other international markets like Australia and South America.
Why do some Nissans break in certain ways?
Nissan vehicles have a tendency to break in certain ways. By collecting data from owners and combining it with information from NHTSA, we can tell you which cars to avoid and what problems happen most. Malfunctions in Nissan’s AEB are causing vehicles to suddenly brake even when there’s no obstructions on the road ahead.
What are the most common problems with Nissan cars?
By collecting data from owners and combining it with information from NHTSA, we can tell you which cars to avoid and what problems happen most. Malfunctions in Nissan’s AEB are causing vehicles to suddenly brake even when there’s no obstructions on the road ahead. The sudden stops…
When did Nissan stop making the Datsun Truck?
The Datsun Truck is a compact pickup truck made by Nissan in Japan from 1955 through 1997. It was originally sold under the Datsun brand, but this was switched to Nissan in 1983. It was replaced in 1997 by the Frontier and Navara.
What are the problems with a Nissan pickup?
The most common problem is the bearings in the transmission wearing out. A Nissan pickup owner can replace the grease in the bearings with a synthetic of the same brand and it will reduce the noise, but the bearings do need to be replaced.
Where is the fuel pump wire located on a Nissan?
Why Nissan used a white/black wire from the relay to the body harness connector (found under the carpet beneath the passenger’s seat) is a mystery to me. All other fuel-related wires throughout the truck are brown as is the connecting terminal in the body harness connector which goes directly to the fuel pump.
What should I do if my fuel pump is not working?
Fuel pump breakers usually have a button on top that pops up when it trips. Simply push this button back in until it clicks. Check the owner’s manual for the exact location. Fuel Pump Testing – If the fuse is good and the circuit breaker is not tripped; then the engine is not getting fuel pressure.
Where is the oil pressure switch on a Datsun?
They are: The ignition switch accessory position (power to blue wire when on). The ignition switch start position (power to white wire at start using fuse #5). The alternator (power to white/blue wire when running). The oil pressure switch or oil sending unit (4WD) (yellow/green).
What kind of fuel pump does a 1981 Datsun have?
I have a 1981 Datsun and a 1984 Nissan and they both have this troublesome black box. Your repair guide not only ignores it, but it is conspicuously absent from the wiring diagrams, making diagnosing and repairing electric fuel pump problems virtually impossible.
I have a 1981 Datsun and a 1984 Nissan and they both have this troublesome black box. Your repair guide not only ignores it, but it is conspicuously absent from the wiring diagrams, making diagnosing and repairing electric fuel pump problems virtually impossible.
A factory relay is labeled Jideco, and if you choose to replace it, they seem to last about 20 years. On the back of the assembly are four Phillips screws. Once removed, the cover and insulator come off and you’re looking at the circuit board of the relay itself.
How can I check the idle stop solenoid?
To check the idle stop solenoid you should turn the key on and check for power at the red wire for the solenoid. Or if powered directly from the battery you should hear it clicking.
How to change thermostat in 1995 Nissan Hardbody Truck?
Raise the front of the Nissan with a floor jack and slide jack stands beneath the vehicle’s frame rails. Lower the truck until only the jack stands support its weight.
What kind of engine did a 1995 Nissan Hardbody have?
The 1995 Hardbody came standard with a 2.4-liter, four-cylinder engine that produced 134 horsepower and had an available 3.0-liter V-6 that created 153 horsepower. A mixture of antifreeze and water, along with a thermostat that opened and closed to control the flow of the water and antifreeze, regulated the temperature of these engines.
Where can I buy Nissan Hardbody off road parts?
Nissan Hardbody (D21) off-road & 4×4 aftermarket parts and accessories at Rugged Rocks. Your source for all your Nissan Hardbody Performance off-road or 4×4 parts and accessories needs.
Raise the front of the Nissan with a floor jack and slide jack stands beneath the vehicle’s frame rails. Lower the truck until only the jack stands support its weight.
The 1995 Hardbody came standard with a 2.4-liter, four-cylinder engine that produced 134 horsepower and had an available 3.0-liter V-6 that created 153 horsepower. A mixture of antifreeze and water, along with a thermostat that opened and closed to control the flow of the water and antifreeze, regulated the temperature of these engines.
How much coolant does a Nissan Hardbody have?
Add 50-50 premixed coolant to the reservoir until it reaches the “Max” line on the reservoir, if needed. The 2.4-liter engine holds a capacity of 2.15 gallons of coolant and the 3.0-liter holds 2.85 gallons. Close the Nissan’s hood.
What happens when an ignition module overheats?
Ignition modules that are overheating will soon completely cease to function and in the meantime can cause cause electrical shorts, engine stuttering, lower gas mileage, power loss, stalling, and gasoline odors in the exhaust.
Why does my Nissan 2.4L not turn over?
In other words, the engine doesn’t turn over at all. This is usually due to a bad starter motor, bad ignition switch, bad neutral safety switch, or the engine is locked up. If this is the case in your particular situation, I recommend testing the starter motor.
What is the Nissan Hardbody Repair Manual for?
Nissan Hardbody Repair Manual 1986-1997 models: Nissan D21 Platform Nissan Datsun (Japan) Nissan Navara (Many markets) Nissan Hustler Nissan Camiones (Mexico 1993–2008) Nissan D21 (China, Chile) Nissan Big M (Thailand) Nissan PickUp Nissan Power Eagle…
What is the repair manual for a Nissan D21?
Nissan D21 Service Manual 1986-1997… Nissan Dualis Repair Manual 2006-2013… item-title: Nissan Elgrand 2010-201X models:… Nissan Frontier Repair Manual D40… item-title: Nissan Silvia S12 Gazelle…
What to do if your Nissan club has an oil leak?
Pull the cooler towards you and replace the seal on the backside making sure the o-ring is inside the inner lip. The other kind is a square pancake cooler that sits midway up the back of most newer 4 cyl’s. Simply remove the bolts, replace the metal gasket and reinstall. Best of luck.
What causes an oil leak in a Nissan?
The oil pans on Nissans very rarely leak unless you hit something with them. Anyone who has said they had a leaking oil pan was likely fed a line and the real issue was fixed without being informed of it (to save face). The number one culprit for oil leaks is in fact the oil cooler. There are two kinds that leak.
What to do if you have an oil leak in your Nissan Frontier?
If the oil leak is coming from your Nissan Frontier’s oil filter or plug, clearly replacing them is going to be the fix. If you do end up changing the plug or oil filter, just make sure to get new oil when you go to the parts store, since you’ll lose engine oil when dealing with either one.
Where does oil leak from in a car?
Oil Pan– The oil pan is a very common place for oil to leak from. Most likely, the gasket that sits between the oil pan and the engine block will go bad. But, it’s not unheard of for an oil pan to crack or get a hole in it. In order to fix an oil leak coming from the pan area, it’s going to take a lot of time, skill, and patience.