What to do if your SRS system is not working?
It stated that if the SRS system had a code stored for either seat belt emergency retractor squib (ETR) and resistance was too high in the electrical circuit (as in your case), then the existing electrical connectors for both seats should be cut-out and replaced using repair kit 230-540-58-05.
Is it necessary to replace the SRS light on my SL500?
To correct the fault in one seat it is unnecessary to replace the connector in both seats. The repair procedure says to remove the seat. This makes soldering-in the new connector easier, but it is unnecessary. You can judge for yourself by raising the front edge of your seat with the seat controls and looking under the bottom cushion.
What to do if your restraint system malfunctions?
Flip open the ‘lock’ on the top of it. Then pull it GENTLY upward. No,it does not slide or twist off. The retractable mechanism is tightly wedged up against the bulkhead with foam. You’ll need lots of patience and strong fingers to slowly wriggle it free.While you are there check the torque on all the bulkhead bolts.
It stated that if the SRS system had a code stored for either seat belt emergency retractor squib (ETR) and resistance was too high in the electrical circuit (as in your case), then the existing electrical connectors for both seats should be cut-out and replaced using repair kit 230-540-58-05.
To correct the fault in one seat it is unnecessary to replace the connector in both seats. The repair procedure says to remove the seat. This makes soldering-in the new connector easier, but it is unnecessary. You can judge for yourself by raising the front edge of your seat with the seat controls and looking under the bottom cushion.
What are the fault codes for Mercedes SRS?
Child seat:”Signal” transmission fault between front passenger seat and “Babysafe” Part E2e5 (Turn signal lamp) in module E2 (Right front headlamp unit) is defective. C1011. BAS light, play in steering column causes steering angle sensor to lose memory (?) C1401.
Flip open the ‘lock’ on the top of it. Then pull it GENTLY upward. No,it does not slide or twist off. The retractable mechanism is tightly wedged up against the bulkhead with foam. You’ll need lots of patience and strong fingers to slowly wriggle it free.While you are there check the torque on all the bulkhead bolts.