What to do if your Jeep Wrangler AC is not working?
The accessory belt should be wrapped around a pulley off to the side of the compressor. If the belt looks damaged or worn in any way, it may be slipping on the pulley and unable to power the compressor. The belt will need to be replaced. Start the engine and turn the AC controls to the coldest setting. Turn the fan speed to the highest setting.
What causes a Jeep Wrangler to stop running?
An accessory belt turns a pulley that is connected to a compressor to deliver the refrigerant to the cabin. When this system malfunctions, there are normally only two possible problems–the system is out of refrigerant, or the belt is slipping on the pulley. Before you replace anything, troubleshoot the problem.
Where is the compressor on a Jeep Wrangler?
The Wrangler uses a rather large compressor on the driver’s side of the engine bay on the bottom of the engine. The accessory belt should be wrapped around a pulley off to the side of the compressor. If the belt looks damaged or worn in any way, it may be slipping on the pulley and unable to power the compressor. The belt will need to be replaced.
Where is the accessory belt on a Jeep Wrangler?
Before you replace anything, troubleshoot the problem. Open the hood of the Jeep and inspect the accessory belt. The accessory belt for the Jeep Wrangler is in the front of the engine. The Wrangler uses a rather large compressor on the driver’s side of the engine bay on the bottom of the engine.
Are there any problems with the Jeep Wrangler battery?
Jeep Wrangler owners have reported 6 problems related to battery dead (under the electrical system category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Jeep Wrangler based on all problems reported for the Wrangler. I have a push to start 2018 Jeep.
What was the problem with my 2002 Jeep Wrangler?
Start run, a little rough, but accelerating fine. After 10 of driving 2800 rpm problem returns. Code P0303 back. Drove the Jeep to the store in very cold temps. Ran rougher than before and got a new code P0135 02 Sensor error, P0300, P0304, P0303, P0305, P0306