What to do if your GM airbag light is on?
If your dealer will not cover the repair, contact the GM customer service center. 1. Disable the airbag system. 2. Replace connectors on both driver and passenger seats. Then reroute and attach the harnesses to the seat using the service kit. 2. Disconnect connector C308 from driver’s seat cross-beam. 3. Remove the driver’s seat.
Is it possible to reset the airbag light without a scanner?
Luckily, in many car models, the airbag light will also go away by itself if you have repaired the problem. In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals.
When does the airbag warning light come on?
There are a variety of different warning lights on the dashboard of a vehicle. Most people will only see them illuminate when there is a particular problem with their vehicle that is indicated by that light. Whether you know it or not, you have probably already seen the airbag light illuminate without even realizing it.
What does it mean when SRS airbag light comes on?
Therefore, when you see the service airbag message pop up, you should immediately get it fixed. What you might also experience with the service airbag message popping up is your SRS airbag light turning on. This may occur if your car was previously involved in an accident that resulted in the crash sensors’ activation without the airbags deploying.
If your dealer will not cover the repair, contact the GM customer service center. 1. Disable the airbag system. 2. Replace connectors on both driver and passenger seats. Then reroute and attach the harnesses to the seat using the service kit. 2. Disconnect connector C308 from driver’s seat cross-beam. 3. Remove the driver’s seat.
Can a GM airbag be replaced for free?
GM will replace the worn/defective connector parts for free as long as your vehicle VIN number is covered by the bulletin (see below for compatibility)
Where are the air bag connectors on a GMC Acadia?
The airbag connectors on some 2008 Buick Enclave, GMC Acadia, and Saturn OUTLOOK vehicles, and 2010 Chevrolet Malibu and Pontiac G6 vehicles may wear, leading to corrosion in the connector terminal pins at the connection between the body main wiring harness and the front driver and passenger side impact air bag.
How long does it take for airbag light to turn off?
Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
The airbag connectors on some 2008 Buick Enclave, GMC Acadia, and Saturn OUTLOOK vehicles, and 2010 Chevrolet Malibu and Pontiac G6 vehicles may wear, leading to corrosion in the connector terminal pins at the connection between the body main wiring harness and the front driver and passenger side impact air bag.
GM will replace the worn/defective connector parts for free as long as your vehicle VIN number is covered by the bulletin (see below for compatibility)
How to turn on the seat airbag light?
Install the blue seals on the body harness and the white seals on the seat airbag harness. Strip the insulation off all four leads 5 mm (3/16 in). Align the seals with the wire insulation. 7. On the body harness, position two FEMALE terminals onto the wires.
What is the trouble code for GM airbags?
GM has issued a service bulletin to address an airbag light on condition along with the following trouble codes: B0012, B0013, B0015, B0016, B0019, B0020, B0022, B0023, B0026, B0033, B0040, B0042 or B0044 on the vehicles listed below. 2006-2014 Chevrolet Corvette, Impala, Malibu Models (includes Malibu Classic)
Can a side impact air bag not deploy?
However, if you ignore the warning light, over time the resistance can increase to a level where the seat side impact air bag may not deploy in a side impact crash. Dealers will replace the front seat-mounted side impact airbag terminals and connector body. If your dealer will not cover the repair, contact the GM customer service center. 1.
How to fix the service airbag light on a GMC Sierra?
To fix this error – you need to disconnect both batteries, drop the skid plate, and replace the Front Impact sensor. The sensor was $65 on Amazon. Thanks everyone for all of your support! Send me stuff! The Tools I Use: https://www.amazon.com/shop/bonecrrus… Loading…
Why does my GM airbag light come on?
The bulletin address a problem with the electrical connectors for the airbag system that causes an Airbag Light on or Service Airbag Message to appear. GM will replace the worn/defective connector parts for free as long as your vehicle VIN number is covered by the bulletin (see below for compatibility)
What was the code name for the Duramax in 2011?
In an effort to keep up with the ever-tightening emission regulations, GM redesigned its Duramax for the 2011 model year, and this time the code name was LML.
However, if you ignore the warning light, over time the resistance can increase to a level where the seat side impact air bag may not deploy in a side impact crash. Dealers will replace the front seat-mounted side impact airbag terminals and connector body. If your dealer will not cover the repair, contact the GM customer service center. 1.
Install the blue seals on the body harness and the white seals on the seat airbag harness. Strip the insulation off all four leads 5 mm (3/16 in). Align the seals with the wire insulation. 7. On the body harness, position two FEMALE terminals onto the wires.