What to do if your Arctic Cat Prowler has no spark?
Your injector is triggered from the ignition signal so it will not spray if you have no spark. Is your engine light on? If so, see if there are any codes in the memory. 1. Make sure the ignition switch is in the OFF position; then remove the seats. 2. Locate the diagnostic plug next to the PDM; then remove the black rubber cap. 3.
Is the Arctic Cat Prowler 550h1 EFI side by side?
2009 Arctic cat Prowler 550H1 EFi side by side flatbed. Will not start! No spark No fuel spray from injector. Fuses good, was running and missfiring and died and would not restart. Replaced plug and injector. no difference. No codes being shown on dash.
How does the injector work on a prowler?
Your injector is triggered from the ignition signal so it will not spray if you have no spark. Is your engine light on? If so, see if there are any codes in the memory.
What to do when your engine has no spark?
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.
Why is there no spark in my ignition?
An ignition module requires some type of external input in order to activate. If your vehicle stalls unexpectedly during operation and will not start again, it is likely because of loose or corroded electrical connections in the ignition module. In this case, check the switch, clean oxidized terminals, and replace broken wires if necessary.
What causes a car to stall with no spark?
Consequently, An old or failing ignition pickup may cut out signal intermittently, which may cause the engine to stall. The engine may suddenly just shut off, almost as if the key had been turned off. Depending on the nature of the issue, sometimes the vehicle can be restarted and driven.