What to do if a head gasket fails on a caterpillar C10?
If a head gasket is the source of the problem this revised cylinder head torque procedure can eliminate repeat head gasket failures on Caterpillar C10 and C12 diesel engines. Replace all cylinder head bolts with p/n 129-3184, reduced shank bolts.
What happens if you change the cylinder head on a caterpillar?
A warped cylinder head or worn valvetrain can lead to decreased engine power, poor fuel economy, overheating and potential engine failure. CTP is the premiere replacement cylinder head supplier worldwide. We specialize in new and improved cylinder head castings that reduce or eliminate the likelihood of engine problems.
How to eliminate head gasket failures on Cat Diesels?
Q. To eliminate head gasket failures on Cat diesels, how should the heads be torqued? A. Pressurizing the cooling system with the oil pan removed can differentiate between a water pump leak and a cylinder head gasket leak before removing the head.
What kind of gaskets do caterpillars use?
CTP’s Graphite, Composite and MLS (Multiple Layer Steel) Head Gaskets are designed and manufactured to provide protection against reduced torque loss and shearing loads. Special coatings, and elastomeric sealing beads are applied on most gaskets to ensure proper oil, water and coolant sealing.
Where is the head gasket on a V-8 engine?
The head gasket is found between the engine block and the cylinder head or heads in a V-type engine. The gasket functions as a seal that prevents the combustion process from leaking into the coolant passages that surround each cylinder. In many cases, it seals oil passages from coolant passages so the fluids do not mix.
How do you replace a head gasket on a car?
Some head bolts cannot be reused and must be replaced. Follow the manual and manufacture requirements. Once all head bolts are out then lift the cylinder head off of the engine block. Look at the head surface and the block along with the gasket for the failure areas.
Is there a serial number for the cat C10?
Caution: Bolt Torques and other data, may vary from serial number to serial number, please check the manuals.
How much does a cat C10 engine weigh?
CAT C10, C12 Weight approx: 1076 kg 2372 lb Click for CAT C10 and C12 engine manuals and specs. CAT C10, C12 Compression ratio 16:1 Click for CAT C10 and C12 engine manuals and specs.
What kind of cylinder head does a caterpillar use?
The new 3406E/C15/C15 ACERT Cylinder Head is well packaged in a durable wooden crate and a convenient nylon lifting straps for safe and secure shipping and handling.
What kind of head gasket bolts do I Need?
Replace all cylinder head bolts with p/n 129-3184, reduced shank bolts. (Jake engines use stud p/n 132-3229). Failure to replace bolts that have corrosion damage may lead to (premature) breakage. Using a straight edge and feeler gauge, check cylinder head/block deck surface for warpage.