What size door speakers are in a 2002 Honda Accord?
Speakers that fit your 2002 Honda Accord*
| Speaker location | Speaker sizes** |
|---|---|
| Corner Dash | Tweeter |
| Front Door | 6-1/2″ |
| Rear Deck Corners | 6×9″ |
How do you change the speakers on a Honda Accord?
Remove one Phillips screw at the top of the speaker, then pry out the top of the speaker. Lift it out, disconnect the wiring harness, and remove it. Then secure the new 5-1/4″ or 6-1/2″ woofer to the adapter bracket and connect the harness. Both of those installation accessories are included at a discount with your Crutchfield speaker purchase.
How do you hook up a stereo to a Honda Accord?
Connect the front door speaker leads to the woofer output on the crossover network, and then run new speaker wire from the crossover to the tweeter. This keeps you from having to pull a new wire through the Molex plug in the door jamb, which is nearly impossible on most Hondas.
What’s the best way to replace a Honda Accord door?
Door Lock Actuator Motors by Dorman®. Restore the ease and convenience of remotely locking or unlocking any one of your vehicle’s doors with Dorman’s Door Lock Actuator Motor. The actuator returns the power door lock to proper… Door Skins by Replace®.
Where is the subwoofer located on a Honda Accord?
The Accord’s optional subwoofer, measuring roughly 8″ in diameter, is located between the two rear deck speakers. Unlike the speakers, it’s secured to a plate that’s welded to the rear deck steel, so getting to it and replacing it is a bit of a challenge.
Where are the speakers on a 2004 Honda Accord?
If you’re considering upgrading the sound system of your 2004 Honda Accord, one of the best places to start is with the speakers. The 2004 Honda Accord featured speakers in two locations—the front doors and the rear deck.
How do you remove a speaker from a door?
Insert the panel tool behind the edge of the door panel and pry around the perimeter to release the clips holding the door panel in place. Lift the panel off of the door to remove it. Unscrew the Phillips screws holding the speaker in place. Remove the speaker from the door, unplugging the connector on the back.
How do you put a new speaker in a car?
Plug the new speaker in, place it in the door and screw it into place. Place the grill back onto the speaker opening and press firmly downwards to seat it in place. Be sure to test your speakers before reassembling the interior panels. Turn off your vehicle’s ignition and set the parking brake before beginning work on your project.