What should the temperature gauge read when the engine is hot?
With a hot engine it should measure 30-50 Ohms. If it reads approx. 140 Ohm (or more) when the engine is both cold and hot then the sensor is faulty and needs to be replaced. If the sensor reads 30-50 Ohms when the engine is hot then there may be a problem with the wiring back to the gauge or with the gauge itself.
What should I do if my temperature gauge reads 50 ohms?
If the sensor reads 30-50 Ohms when the engine is hot then there may be a problem with the wiring back to the gauge or with the gauge itself. Make sure the engine is turned OFF and that the vehicle’s ignition key is in your pocket when you test the sensor. Also don’t burn yourself on the engine block when the engine is hot Was this answer helpful?
What to do if your car temperature gauge is inoperative?
To diagnose an inoperative temperature gauge, you’ll need to test the coolant temperature sensor and the wiring for that circuit. You should have a service or repair manual written for your specific vehicle prior to attempting these tests.
Why does the temperature gauge stay on cold?
Air in the coolant system can also cause the temperature gauge to stay on cold if there is an air bubble right at the sensor spot. This can also often be indicated with a fluctuating coolant temperature gauge. If you suspect air in the coolant system, you have to bleed your coolant system with a unique technique.
What should I do if my temperature gauge keeps going cold?
In some cases, you can replace the temperature gauge or repair any bad solderings if you find any. In other clusters, you might have to replace the instrument cluster. You can often leave your instrument cluster to an expert to repair the soldering if you do not know how to yourself.
How does the temperature gauge work on a car?
The temperature gauge reading starts out as a reference voltage that is sent to the coolant temperature sensor. This sensor is nothing more than a thermistor — a variable resistor that changes resistance with temperature changes. As the coolant temperature rises or falls, the resistance of the sensor changes as well.
How can I tell if my temperature gauge is inoperative?
To diagnose an inoperative temperature gauge, you’ll need to test the coolant temperature sensor and the wiring for that circuit. You should have a service or repair manual written for your specific vehicle prior to attempting these tests. You will need to drain and fill the cooling system as well as test specifically colored wires.
What do you mean by temperature gauge is fluctuating?
Temperature gauge is fluctuating, sometimes showing overh… Q: Temperature gauge is fluctuating, sometimes showing overheating.
Where is the temperature sensor on the dashboard?
The one on the left, where the single wire black connector has been disconnected is the sending unit for the dashboard gauge. The one on the right with the grey connector (and being held by fingers) is the ECU temperature sensor.
How to test the temperature of the ECU?
The one on the right with the grey connector (and being held by fingers) is the ECU temperature sensor. To test the sending unit, disconnect the single wire black connector and using a DMM (Digital Multimeter – Ohmmeter function) measure the resistance between the sending unit terminal and earth (or ground – the engine block will be earthed).