What should I do if my ignition switch is failing?
If the switch is failing, you will probably not hear any clicks from the main relay, which fires the ignition. Check the behavior of the dashboard lights if your vehicle stalls as mentioned before. Alternatively, when the key is first turned to position two, the oil light, brake light, charge light, and other warning lights will not function.
What are the symptoms of a failed ignition relay?
Car suddenly stalls while operating: One of the most common symptoms of a failed ignition relay is a car that suddenly stalls while operating. If the ignition relay shorts, burns out, or otherwise fails while the engine is operating it will cut off power to the fuel pump and ignition system.
How can I check the integrity of my ignition switch?
You can try a test to check the integrity of the ignition switch by turning the ignition key to the ‘start’ position. As soon as it tries to start, let go of the key. Allow it to snap back to the ‘run’ position and note warning lights.
Where can I get an aftermarket ignition switch?
You can sometimes get aftermarket ignition switches from your local auto parts store as well. Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module.
What happens if there is no power to the ignition switch?
If fuse is good check for power being available at the ignition switch connector. If no power there, check wiring between PDC and the ignition switch-if power is up to the switch, but nothing happens with key on, no dash or warning lights, then could have a bad ignition switch. It just sounds like a maxi-fuse has blown, or a bad fusible link.
What to do if no power to ignition or headlights?
And its the only thing left on the checklist that is in line to power the solenoid and headlights. Purchased an aftermarket ignition and spliced it in place of the old ignition switch. A starter relay was inexpensive so I purchased one just in case. I put the old starter relay back into the plug.
Which is the main hotlead on an ignition switch?
Main hotlead is the one that is common to all switch positions. run and accessories is to the post that is hot with key on, accessory only is the one only hot with key turned backwards. You can’t post conmments that contain an email address.
Why does the ignition switch need to be in the Accessory position?
The ignition switch must be in this position before the driver can remove or insert the key. Accessory: In this position, the ignition switch supplies battery power to the vehicle’s accessories, such as the radio and lights. But it doesn’t provide power to the engine control circuits.