What should I do if my Hyundai Accent fuel pump is failing?
You should first connect a pressure gauge and check the fuel pressure, which should be around 40 lbs. They should be maintained when closing the switch. Does this mean that it might be the fuel pump that is failing, JOHANNES? It worries me, but at the same time, when the engine is already warm, the failure tends to get better.
Is there a problem with the Hyundai Accent battery?
Changed battery terminals was ok for awhile. Going to check ground on engine and live wire to starter for corossion. Was told by dealer it was charging ok,will also check that again. Car is being used on short runs only. Will also take battery out and give it a good charge. Confused but never give up LOL.
Why does my Hyundai Accent vibrate at idle speed?
The mechanic I use, found that the engine ground was faulty. They replace the ground wires and all is well. My car vibrates way too much at idle speed. I’ve been having this problem for quite a long time now and, when scanning it, there is no error indicated.
Why is the ABS not working on my Hyundai Accent?
It appears a sensor has failed. The car has less than 42k miles and is in perfect shape. When the car turns over, the brake, traction control, and abs light stays on, the speedometer doesn’t move when in motion and the fuel range switches numbers while in motion.
Where are the injectors on a Hyundai Sonata?
The bottom row has 5 wires from left to right, gray no power, pink w/black strip no power, green w/black strip with power, black no power, pink with power. This is the plug coming from the fire wall. sir…… Ok, you should have voltage on the pink wire under the orange/black. This is the feed to the injectors from the injector fuse.
Why is my Hyundai Accent stalling on the highway?
Oxygen Sensor – The oxygen sensors measure the exhaust gasses after they exit the combustion chamber. The ECU uses this data to make adjustments to the air/fuel mixture. If one of them has gone bad, then it could lead to stalling. There are many other sensors that can cause your Accent to stall.
What should the pressure be on a Hyundai Sonata?
If you block the end of the line it should be 80 psi, when it is running through the regulator on the rail it drops to 35 – 40 but it should be a solid stream not just a trickle. It sounds like you don’t have pressure. The pump is easy to remove if you already have the access cover off but a pump module is expensive.
Why is there no power going to fuel pump?
There are a lot of things that need to be verified before replacing any other parts as this will eventually become very expensive. Many times, the battery has failed and the vehicle will not start or provide power; it could simply be worn out or there could be a parasitic draw or a weak alternator that is not properly charging.