What motor is in a 2011 Duramax?
6.6L Duramax LML Specs
| Engine: | 6.6L Duramax LML, 90 degree V8 diesel |
|---|---|
| Years Produced: | 2011 – 2016 model years |
| VIN Code: | 8 (8th digit of VIN) |
| Displacement: | 403 cubic inches, 6.6 liters |
| Assembly Site: | DMAX engine plant, Moraine, Ohio |
How long do Chevy truck transmissions last?
Automatic Transmissions This type of transmission usually lasts between 150,000 and 200,000 miles. As always, with proper maintenance and care, it is possible to extend the life of your transmission past 200,000 miles. Chevy Silverados are usually automatic, so you can hope to see your transmission last 200,000 miles.
How do I identify a 6L90 transmission?
there is a 4 digit designation on it… the first digit is a number and designates the Model yr… the 2nd digit is either a “B” or a “C” or a “D”….. the B is for 6L50, the C is for a 6L80, and the D is for a 6L90….. so for example…. a 1DKA is a 2011 model yr 6L90 transmission…. the last two letters is the …
Is the GM 6L80 a good transmission?
The 6L80 is doubtless a very successful OEM transmission, and a terrific conversion transmission in the right Jeeps and situations. However, it is a long transmission and is not compatible with short-wheelbase Jeeps such as the CJ5.
Which is 6 speed transmission does GM 6L90 use?
The 6L90 is a heavy-duty version of the 6L80 six-speed automatic, with a strengthened input gearset that has two additional pinion gears (six in total) and a strengthened output gearset that uses wider gears than the 6L80.
How to install manual transmission in GM 6T70?
With engine at idle, shift from REVERSE to DRIVE and leave shift lever in DRIVE for five (5) seconds. After five seconds, shift back to REVERSE and leave shift lever in REVERSE for five seconds. Perform this procedure twenty (20) times (R-D-R-D-R-D…).
Do you need a dipstick for a 6L80 transmission?
Plate-type oil-to-air (OTA) transmission coolers must always be replaced. Entire transmission cooling system must be completely cleaned, hot flushed, and flow tested. 6L80 / 6L90 transmissions do not typically use a dipstick. Proper fluid level is achieved when fluid begins to drip from the Level Control Plug opening.
How to install guide for 6L80 automatic transmission?
With engine at idle, shift from NEUTRAL to DRIVE and leave shift lever in DRIVE for five (5) seconds. After five seconds, shift back to NEUTRAL position and leave shift lever in NEUTRAL for five seconds. Perform this procedure ten (10) times (N-D-N-D-N-D…).