What kind of rivets to use on patch panels?
TECH TIP: Use only aluminum rivets and patch panels on aluminum, and steel rivets and patch panels on steel. After the rivet pattern is laid out accurately, clamp the patch panel in place using supplied edge clamps and c-clamps if needed. Make sure to check for flush (level) positioning of panels using the straight edge as before.
What do rivets do on the front of a car?
They are used to hold onto the door panels, on dashboards, some covers in the engine bay, body trim pieces and of course splash panels. They are either “Christmas tree” types, which are most common, or rivet styles that either screw in or get pushed in.
What kind of hole do you need to drill for rivets?
Start drilling the rivet holes, with a 1/8″ bit, beginning in a corner, using supplied blind holders in drilled holes to help secure panel. Once holes are drilled, remove clamps and patch panels and deburr all holes; this will assure a flush repair in the end.
What’s the best way to remove a panel rivet?
Slide these tools under the head of push-in rivets and squeeze the handles to pop the rivet out. They are also known as panel clip pliers. Attach this tool to your drill to remove all styles of domed head rivets. These tools pull the rivet bolt tight to the collar, clinches the collar in place, and clips any excess length of the bolt.
What kind of rivets to use on button heads?
A larger head diameter than standard domed head blind rivets covers irregular holes and provides extra holding power when fastening soft, thin material to a rigid backing. They’re also known as large-flange blind rivets. These rivets are lightweight and have good corrosion resistance. 18-8 stainless steel has good corrosion resistance.
What are the rivets on a belt used for?
Also known as belt rivets, these are used for fastening conveyor belts or leather. A special setting tool and a hammer are required for installation. Hammer the pin into the body and it flares out for a secure hold. These rivets require access to only one side of the material and can be used in through-holes or closed-end holes.
What kind of rivets are made of aluminum?
Made of aluminum, these blind rivets are lightweight and corrosion resistant. The domed head gives your project a finished appearance. Made from 18-8 stainless steel, these blind rivets create a strong hold even in wet and damp areas. The domed head gives your project a finished appearance.