What kind of controls does a Yamaha Virago have?
JAPANESE YAMAHA VIRAGO. JARDINE FWD CONTROLS INSTRUCTIONS PG.2 RIGHT REAR MOUNT BOLT AND BRAKE ARM WITH EXTENSION ROD BRAKE PEDAL ARM MOUNT WITH COTTER KEY LEATHERLIKE BAG MOUNTING BRACKET LOWERED LEATHERLIKE BAGS, CLICK ON “ORIGINAL” FOR A LARGER VIEW
How to re-Jette a virago air tube?
REMOVED LEFT SIDE BUGEYE AND CAPPED OFF VACUUM LINES. COST FOR KIT AND COVER WAS $140.00, BUT RE-JETTING IS ALSO REQUIRED FOR THE KJS KIT, START BY INSERTING THE BUGEYE AIR-TUBE INTO THE SE BACKING PLATE MARK WITH MASKING TAPE, WHERE YOU ARE GOING TO MAKE YOUR CUT THIS IS WHERE I ENDED UP CUTTING THE TUBE SLIDE THE VELOCITY STACK OVER THE TUBE
How to change the brake pedal on a virago?
APPLY LIBERAL AMOUNT OF RTV SILICONE ON THE BACK SIDE, SMOOTHING IT WITH A MOIST FINGER FOR THAT NEATER LOOK (?) I HAVE ADDED AN ADDITIONAL BRACKET TO STABILIZE THE CARBURETOR MAKING AN EXTENSION FOR THE BRAKE PEDAL HELPED “KRANK VENT” INSTALLATION, THERE ARE FOUR PHOTOS THAT CHANGE AUTOMATIC LY
What is the fuse box on a virago?
THIS VIEW SHOWS THE POWER SUPPLY WIRE, AS WELL AS THE TOW VEHICLE CHARGING WIRE. THE FUSE BOX IS A PLASTIC CUTOFF HOUSEHOLD TYPE SIMILAR TO WHAT IS USED FOR AN AIR CONDITIONER IN THIS VIEW YOU CAN SEE THE TWO INTERIOR SIDE 12 VOLT SIDE LIGHTS MAC vs STOCK EXHAUST.
Where is the synch screw on a virago?
This synch is accomplished by turning the synch screw located between the carbs in the back. You’ll most likely need to remove the rear carb breather pipe to get to the screw, and move the tank up out of the way a bit using the 30mm socker works great if you have one.
How to Rev A viragotech to 4000rpm?
You’ll most likely need to remove the rear carb breather pipe to get to the screw, and move the tank up out of the way a bit using the 30mm socker works great if you have one. Once you get to it, it is usually quite simple to rev the bike to 3-4000rpm, hold it there, and check your synch.
How to make a viragotechforum tune an engine?
Now take the ink tube and cut it in half. At the top of the yard stick cut the PVC tubing and stick each end of the ink tube in the ends of the PVC tubing secure it with some RTV i used some high tack RTV. Let this try for 3 hours. When in use with the engine running both lines must be connected, one to each carb.
How big should the bottom of a viragotechforum be?
Fill with oil to about the 26 or 27 inch mark (36 at the bottom). You may have to leave the unit sit for a day or so to get all the bubbles out. If you are careful not to introduce air when filling this is less of a problem. Now take the ink tube and cut it in half.