What kind of brakes did Pontiac Trans Am have in 1979?
The 1979 model year brought a major change to the Special Performance Package (RPO WS6). When you checked that option on the order form, you received four-wheel power disc brakes. Having rear disc brakes in 1979 was considered exotic and, in the GM family, they were usually only available on the Corvette.
Are there rear disc brakes on a Pontiac Firebird?
When you checked that option on the order form, you received four-wheel power disc brakes. Having rear disc brakes in 1979 was considered exotic and, in the GM family, they were usually only available on the Corvette. Rear disc brakes greatly simplified repairs and improved braking performance.
What should I do with my Trans Am brake caliper?
It may be necessary to have a drain pan underneath or at least a shop rag to catch the residual fluid. The brake caliper should pivot and lift off the mounting bracket. If it’s stubborn, wiggle the caliper off with a rocking motion.
Where is the brake hose on a 1979 Pontiac Firebird?
Install the brake hose by placing one end at the caliper and installing a new copper washer, which should have been included with the new hose. Reuse the bolt you removed earlier. The 1979 model year brought a major change to the Special Performance Package (RPO WS6).
The 1979 model year brought a major change to the Special Performance Package (RPO WS6). When you checked that option on the order form, you received four-wheel power disc brakes. Having rear disc brakes in 1979 was considered exotic and, in the GM family, they were usually only available on the Corvette.
It may be necessary to have a drain pan underneath or at least a shop rag to catch the residual fluid. The brake caliper should pivot and lift off the mounting bracket. If it’s stubborn, wiggle the caliper off with a rocking motion.
What kind of brakes did the Pontiac Firebird use?
The stock front disc and rear drum brakes used on the second-generation Firebird were extremely robust and efficient. Depending on which road test you read, the disc/drum setup on the Firebird took about 160 feet to stop from 60 mph.
What kind of brakes did the Pontiac Trans Am have?
The new four-wheel disc brakes on the WS6 cars knocked some time from the stopping distance, bringing the Trans Am to 60 mph in only 146 feet. This 1978 Formula W72 was a limited-performance model with a 400-ci engine, which produced 220 hp and 320 ft-lbs of torque. Here, the front brakes are shown.
Where do you Bleed the brake lines on a Pontiac Grand Prix?
It is recommended that you begin bleeding the brakes lines at the wheel farthest from the master brake cylinder and then working your way towards the brake cylinder. On the 1997-2003 Grand Prix, that would be rear passenger wheel first, then the driver side rear wheel, passenger side front wheel and finally the driver side front wheel.
When to release the brake pedal after a bleed?
It’s important that the person assisting does not release the brake pedal until the bleeder screw has been closed. If the pedal is raised with the bleeder screw still open, old fluid and possibly air will be sucked back into the system negating the whole purpose of the procedure.