What kind of brake system does sprinter 3500 have?
In the rear, there are two different brake systems on the Sprinter for the 2500 and 3500 models. The 2500 uses a single piston floating caliper, and the 3500 uses a dual piston floating caliper. Both versions use a drum-in-hat emergency brake.
How to adjust the parking brake on a sprinter?
Mercedes Sprinter – Adjust the Parking – Hand Brake – How Does it work? – Howto – YouTube If playback doesn’t begin shortly, try restarting your device.
What causes brake wear on a Sprinter van?
This usually results in front brake wear. In TSB 08-028-06 for first-generation Sprinters, Chrysler states that a burned out or incorrect type brake light bulb could result in unrelated DTCs in the ECM or ABS/ESP control module.
How big is the brake caliper bracket on a sprinter?
For second-generation vehicles, there are two specifications for M10 and M8 bolts. M10 bolts should be tightened to 24 ft/lbs. M8 bolts need to be tightened to 48 ft/lbs. The rear brake caliper bracket on first-generation Sprinters has a torque specification of 66 ft/lbs for M12X1.5 bolt and 125 ft/lbs for M14X1.5 bolt.
In the rear, there are two different brake systems on the Sprinter for the 2500 and 3500 models. The 2500 uses a single piston floating caliper, and the 3500 uses a dual piston floating caliper. Both versions use a drum-in-hat emergency brake.
Mercedes Sprinter – Adjust the Parking – Hand Brake – How Does it work? – Howto – YouTube If playback doesn’t begin shortly, try restarting your device.
What happens when the parking brake does not release?
Parking brakes can be mind boggling when it does not release. When the parking brake does not release, you can damage the transmission or engine trying to overcome the braking force. The parking brake system is simple in design and helps keep the vehicle from moving when placed at rest.
For second-generation vehicles, there are two specifications for M10 and M8 bolts. M10 bolts should be tightened to 24 ft/lbs. M8 bolts need to be tightened to 48 ft/lbs. The rear brake caliper bracket on first-generation Sprinters has a torque specification of 66 ft/lbs for M12X1.5 bolt and 125 ft/lbs for M14X1.5 bolt.