What kind of bell housing does Ford use?
A list of bell housing patterns for General Motors transmissions is also available, as is a list of engines for Ford Motor Company. Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some “big block”-sized V8’s as well as some V6’s and I6’s. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern.
Where is the bellhousing on a GM car?
A rear wheel drive bellhousing is displayed at right. Nearly identical to the GM small corporate/metric pattern, except that the starter is located between the cylinder banks, and the lower right bolt hole is moved outward by roughly one inch. Being nearly identical, it too has the distinctive odd-sided hexagonal shape.
What kind of bellhousing pattern does a GM V8 have?
Generation III V8s with modifications. These modifications include an additional bolt hole at the top of the pattern, and attachment points for cast oil pans to lower bellhousing extensions, to reduce NVH. This pattern has a distinctive odd-sided hexagonal shape.
How big are the bells on a Chevy?
Chevrolet has always had just two sizes of flywheel: Big (168 tooth 14″ diameter) and Small (153 tooth 12.75″ diameter), with the 153 tooth flywheel being introduced in 1963. The early bells were cast iron with the aluminum bells being phased in.
A list of bell housing patterns for General Motors transmissions is also available, as is a list of engines for Ford Motor Company. Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some “big block”-sized V8’s as well as some V6’s and I6’s. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern.
Generation III V8s with modifications. These modifications include an additional bolt hole at the top of the pattern, and attachment points for cast oil pans to lower bellhousing extensions, to reduce NVH. This pattern has a distinctive odd-sided hexagonal shape.
A rear wheel drive bellhousing is displayed at right. Nearly identical to the GM small corporate/metric pattern, except that the starter is located between the cylinder banks, and the lower right bolt hole is moved outward by roughly one inch. Being nearly identical, it too has the distinctive odd-sided hexagonal shape.
When did GM stop using round top bellhousing patterns?
Some transmissions, most notably the TH200-4R, take advantage of this by integrating both specifications into a “universal” bolt pattern casting. Early Cadillacs manufactured before 1965 used a “round top” bellhousing very similar to early Buicks; around 1965, the bellhousing pattern was revised until the BOP bolt pattern was adopted in 1968.
What kind of bellhousing does a Ford Pinto have?
The 4.0L bellhousing and the 3.0L bellhousings “MAY” interchange, but they do not interchange with the previous Cologne engines. 1.3/1.6/1.8/2.0/2.3/2.5L OHC I4 RWD. This engine was also produced in Cologne, Germany. It was put in Pintos, Mustangs, Fairmonts and Rangers.
Are there bellhousings for the same clutch Forks?
Ford used the same bellhousings throughout many years and decided to keep the same codes. The clutch forks will interchange between the 164 and 157 tooth bellhousings, but be sure to look up the part number stamped on them to double check what you have.
What is the date on a Ford bellhousing?
This 157 tooth bellhousing has a 1965 date code on it. This 164 tooth bellhousing has a 1965 date code on it, however it was behind a ’69 302 with a 4 speed top loader. These codes should be used more as a part number as opposed to a date code. Ford used the same bellhousings throughout many years and decided to keep the same codes.