What is the trouble code on a John Deere?
Diagnostic trouble codes of the engine control unit (ECU) Diagnostic Trouble Code – Display – Decision ECU 000097.03 – Engine system – The problem with the signal Water in the fuel. Arrange repair as soon as possible through a John Deere dealer. ECU 000097.04 ECU 000097.16 – Engine water trap full – Remove water from water trap.
What is the ECU code on a John Deere?
ECU 000097.04 ECU 000097.16 – Engine water trap full – Remove water from water trap. ECU 000100.01 – Engine oil pressure low – Check engine oil level. If the code returns, arrange for repair immediately through a John Deere dealer. ECU 000100.03 – Engine system – The problem with the voltage signal of the oil pressure in the engine.
Is the John Deere 9200 in good condition?
The exterior is in good shape with no or little damage to the body or the paint. The interior is in good condition with some tears in the seat. The engine compartment look to be in good condition. The rims are slightly damaged, tires are holding air. The hydr…
What to do if you have a John Deere fault?
ECU 000110.16 Check coolant level. Inspect and clean the radiator. If the code returns, arrange for repair as soon as possible through a John Deere dealer. ECU 000110.17 Low engine coolant temperature. To warm up the engine. If the problem persists, arrange for repair as soon as possible through a John Deere dealer.
What should I do if my John Deere engine is clogged?
The air temperature in the intake manifold is high. Engine power is limited. Reduce engine load and speed. Check the cooling system for contamination. ECU 000107.00 Engine air filter clogged.
What kind of engine is 310jand310sj backhoeloader?
BackhoeLoader 310Jand310SJ Engines4045DT060, 4045HT054and4045TT094 *OMT210365* 310Jand310SJBackhoeLoaders OPERATOR’SMANUAL Engines4045DT060,4045HT054 and4045TT094
What does Diagnostic Code E mean on John Deere transmission controller?
If the third digit of the diagnostic trouble code number is (A or E), it indicates a problem with B8 Rear (LH) Pump Pressure Control Pilot (PCP). If the third digit of the diagnostic trouble code number is (C or D), it indicates a problem with B9 Front (RH) Pump Pressure Control Pilot (PCP).
How tall is a 310g John Deere backhoe?
Backhoe 310G With Standard With Extendable Dipperstick* Backhoe* Retracted Extended ALoading height, truck loading position …………………………10 ft. 11 in. (3.33 m) 11 ft. 1 in. (3.38 m) 13 ft. 11 in. (4.24 m)
Why do I get PTR 522456.31 on my Tractor?
The ptr 522456.31 is caused by shifting the transmission without fully depressing the clutch typically. There can be a problem with the clutch pedal potentiometer or bottom of travel switch as well. About a year and a half ago, there was new software available to reduce the occurrence of this code.