What is the top speed of a Polaris Predator 500?
The Polaris Predator 500 top speed is 73 mph, a decent baseline reading for a 415-pound ATV.
How does the carburetor work on a Polaris ATV?
The carburetor on your Polaris ATV is used to bring fuel into the engine. If you are getting stalls or your engine will not turn over, you need to adjust the carburetor. Jet pins and an air adjustment valve are attached to the carburetor. This valve will allow you to reduce or increase the air flow to your engine.
How do you adjust jet pins on Polaris carburetor?
Open the owner’s manual and locate the adjustment chart. Tighten the jet pins with a screwdriver until they will not go any tighter. This calibrates them to zero. Refer to the adjustment chart to see how many turns the pins need for the proper calibration. Use the screwdriver to adjust the screw on the air valve the same as the jet pins.
Where is the fuel mixture screw on a Polaris Magnum 325?
I’ve found the very obvious idle screw but I don’t know where the fuel mixture screw is. My polaris magnum 325 idles poorly (very slow and dies sometimes) and it has been back firing a lot and smelling like gas. Is the mixture screw on the inside of the carb or outside?
How to adjust the idle screws on a Polaris?
Charles Poole holds a Bachelor of Arts in creative writing from Appalachian State University. He started freelancing in college for local publications in Boone, N.C. and is continuing his career through online freelancing with a specialization in affiliate marketing, blogging and SEO. How to Adjust the Idle Screws on a …
How do you adjust the carburetor on a Polaris ATV?
Turn off the engine and remove the ignition key. Wait for the ATV to cool. If you do not, you might burn your hands while adjusting the carburetor. Locate the gold pins on the side of the engine. The fuel jets and the air valve are on the bottom of the engine. Open the owner’s manual and locate the adjustment chart.
I’ve found the very obvious idle screw but I don’t know where the fuel mixture screw is. My polaris magnum 325 idles poorly (very slow and dies sometimes) and it has been back firing a lot and smelling like gas. Is the mixture screw on the inside of the carb or outside?
Where are the jet pins on a Polaris carburetor?
If you do not, you might burn your hands while adjusting the carburetor. Locate the gold pins on the side of the engine. The fuel jets and the air valve are on the bottom of the engine. Open the owner’s manual and locate the adjustment chart. Tighten the jet pins with a screwdriver until they will not go any tighter.
Charles Poole holds a Bachelor of Arts in creative writing from Appalachian State University. He started freelancing in college for local publications in Boone, N.C. and is continuing his career through online freelancing with a specialization in affiliate marketing, blogging and SEO. How to Adjust the Idle Screws on a