What is the fuel injection code on a Honda Civic?
The fuel injection computer on your Honda Civic is designed to sense when the crankshaft position (CKP) sensor is bad and set one of the following diagnostic trouble codes. P0335: CKP Sensor No Signal.
Why does my Honda Civic crank but not start?
There are times when the crank sensor has failed (and causing your Honda Civic to crank but not start) yet the fuel injection computer does not set a code. When this happens… the two symptoms that you can count on seeing are: No fuel injector pulses (when tested with a Noid light).
How does the crank sensor work on a Honda Civic?
Feeds the PCM with the signal the crank sensor creates. Ground. Feeds the crank sensor with chassis Ground. Power. Feeds the crank sensor with power (12 Volts DC) from PGM-FI main relay 1. NOTE: You can find the crank sensor wiring diagram here: 2001-2005 Crank Sensor Wiring Diagram (Honda 1.7).
How do you test a new Honda Civic?
Here are the test steps: Jack up your Honda Civic and place it on jack stands (to gain access to the crank sensor). Once on jack stands, remove the driver side water splash shield. Disable the ignition system by disconnecting each individual ignition point from its harness connector .
What happens when the crank sensor on a Honda Civic goes bad?
The most obvious symptom that your Honda Civic will experience, when the crank sensor fails, is a ‘ cranks but does not start condition ’. The fuel injection computer on your Honda Civic is designed to sense when the crankshaft position (CKP) sensor is bad and set one of the following diagnostic trouble codes. P0335: CKP Sensor No Signal.
When does limp mode start on a Honda Civic?
On start up, the car will go the distance at any speed for as long as needed; just as long as there is no continuous stop and go traffic. Not long after this type of traffic begins, Limp Mode occurs; 10-15 mph max; even when floored.
When to reset the Check Engine light on Honda Civic?
Continue reading to learn how to reset this light and save yourself the dealership cost. This article applies to the Honda Civic (1992-2000), and Accord (1990-2002). The check engine light in your Honda offers important diagnostic information, which will alert you of a serious problem like a bad catalytic converter.
What is the diagnostic code for a Honda check engine light?
Refer to our Generic OBD II code list for definitions on all other Honda diagnostic trouble codes. P1201 Cylinder 1 Misfire – Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0301
What is the DTC code on a Honda Accord?
MIL will indicate DTC’s by outputting a number of flashes. Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Honda diagnostic trouble codes. Manufacturer Specific Codes P1106BARO Circuit Range/Performance Malfunction P1107BARO Circuit Low Input P1108BARO Circuit High Input
Where can I find the OBD code for my Acura?
If there is no procedure for your manufacturer specific code, then I suggest referring to a similar generic OBD II code (these are listed numerically by system type) to get a good idea of what to look for. If at this point you still need assistance use the “Get Help” link and let us know how we can help.