What is the error code for bank 1?
Table of Contents. Error code P0012 is a generic code which indicates that ECM believes the intake camshaft timing for bank 1 is more retarded that it was instructed to be. This condition can be detected during the advancing or retarding section of the camshaft timing process.
What are the fault codes for variable valve timing?
P0010….A Camshaft Position Actuator Circuit Bank 1 P0011 ….A Camshaft Position Timing Over-advanced or System Fault Bank 1 P0012….A Camshaft Position Timing Over-retarded Bank 1 P0013….B Camshaft Position Actuator Circuit Bank 1 P0014….B Camshaft Position Timing Over-Advanced or System Fault Bank 1
What should I do if my OBD-2 fault code comes back?
The codes should then be reset to clear the OBD-II fault codes and retest the vehicle to see if the P0012 code comes back. Commands the oil control solenoid valve on and off to see if the camshaft timing changes.
Which is Bank 1 on a car engine?
The “A” camshaft is either the intake, left, or front camshaft. This code is specific to bank 1. Bank 1 is the side of the engine that contains cylinder #1.
P0010….A Camshaft Position Actuator Circuit Bank 1 P0011 ….A Camshaft Position Timing Over-advanced or System Fault Bank 1 P0012….A Camshaft Position Timing Over-retarded Bank 1 P0013….B Camshaft Position Actuator Circuit Bank 1 P0014….B Camshaft Position Timing Over-Advanced or System Fault Bank 1
What causes a VVT self test to fail?
Normally due to cold start up. The failure of this VVT self-test stems from the exceeded minimum calibration of the camshaft timing or it remains in an retarded position. Bank 1 is the side of the engine that contains the #1 cylinder.
Is the VVT oil flow valve on or off?
Of course, technicians will use an advanced scan tool to check the status of the VVT oil flow valve. Typically, it should be On at higher engine RPM and Off at idle. He will also scan and document the engine codes and check the freeze frame data to see exactly where the code was set.
Which is the Bank One of the engine?
Bank one is the side of the engine containing cylinder one. Finally, the “B” camshaft is the exhaust, right or rear camshaft, depending on the vehicle. Left/right and front/rear are from the perspective of the driver.