What is the DST code on a Hino j05d?
Hino J05d/J08e Engine ECU Fault Codes List Diagnostics Trouble Codes P-Code DST-1 Display Remarks Description P0045 VNT Malfunction For the VNT. The VNT actuator has a malfunction. P0049 Turbo Charger Turbine Over speed The turbine rotation sensor has been detected. Over speed of the turbo has been detected. P0088 Common Rail Pressure -Too high
How does the Hino quick reference guide work?
The Quick Reference Guide is designed to help you quickly look up parts for commonly ordered parts. The format has been changed from previous years. The main sections are in alphabetical order but the Sub-sections are not. The PART NAMEis listed in the first column.
Why do I need to replace the ECU on my Hino?
There are possibilities of the sensor malfunction, open and short circuit to +B in the harness.” The voltage for the injector activation is too high. Replace the ECU.
What are the five groups of Hino parts?
HINO uses five major groups. Engine – Electrical – Drive – Cab Rear Body and Chassis/Tool The sixth column is the FIGURE #that the part can be found in the Hino Electronic Parts Catalog and is helpful if you need other parts in addition to what’s listed in the Quick Reference Guide. See the example shown above from the EPC.
Can a fault code be erased on a Hino truck?
On models with a DLC3 diagnostic connector, fault codes can be erased with a tester. Note: when the battery is disconnected, the memory of other electronic devices (watches, etc.) is erased. 3. Carry out road tests of the car. A. Repeat the diagnostic procedure and verify that there are no fault codes.
What is the code for a Hino pressure sensor?
P0117 HM 11 Coolant temperature sensor, the value is below normal. P0118 HM 11 Coolant temperature sensor, a value above normal. P0191 pressure sensor in the common rail, a mechanical problem. P0192 pressure sensor in the common rail, a value lower than the norm. P0193 pressure sensor in the common rail, a value above normal.
When is there no Ne signal on a Hino truck?
There is no “NE” signal to the electronic control unit for 2 seconds or more when the crankshaft is cranked by the starter. 1. Open or short circuit in the sensor circuit of the shaft speed sensor pump.
How is the fault code of a Hino truck determined?
5. The malfunction code is determined by the series of outbreaks “tens-units” of the warning lamp. 6. For example, the lamp flashes 1 time, then a pause of 1.5 seconds, then flashes 3 times. This means code 13. 7. If two or more fault codes are stored in the memory of the electronic unit, the codes will be separated by a pause of 2.5 seconds.