What is the diameter of a post hole digger?
Power Planter’s augers come in sizes ranging from two to nine inches in diameter. The 2- and 3-inch diameter augers can be powered by a regular power drill. They come in lengths ranging between 7 inches and 48 inches.
Do post hole diggers come in different sizes?
Most gas-powered post hole diggers have interchangable augers available in sizes from 2″ through 10-12″ diameter, depending on the size of hole you need to dig.
What size auger bit bore a hole with a diameter of 5/8 inch?
STAR-M Auger Bits in Inch Measurements
| Diameter inch | Diameter mm | Shaft mm |
|---|---|---|
| 3/8 | 9.52 | hex 6.35 |
| 1/2 | 12.7 | hex 6.35 |
| 5/8 | 15.85 | hex 9 |
| 11/16 | 17.38 | hex 9 |
How deep can you dig with a post hole digger?
Post hole diggers have a maximum effective depth of about 3/4 of their handle length, so a five foot pair will dig about 3 1/2 half deep. Very hard earth like clay is extremely difficult to dig with a manual pair of post hole diggers.
What size auger is needed for 4×4 post?
Post Holes- For example: A 4×4 post (actual size 3.5″x3. 5″) has a maximum width of just over 5″ (diagonally). Therefore, the 4×4 post will likely fit into a hole drilled by a 6″ diameter auger.
What size auger do I need for fence post?
You’ll be able to get away with a 6-in. auger for steel fence posts. Keep in mind that you’ll need a larger hole (and a larger auger) if you’ll be filling around the post with concrete. The 4-in.
How do you measure auger bit size?
The measurement which determines the hole size is the distance between the center of the screw point and the outer edge of the protruded cutting lips.
What size hole to dig for 4×4 post?
9-12″
A general rule of thumb is to dig the diameter of the hole at least 3-4 times the diameter of the post. For example, if setting 4 x 4 wood posts, dig holes 9-12″ in diameter. Posts should be centered in the hole and the posts should always have concrete under them.
What kind of post hole digger does Digga use?
Tractor Post Hole Digger. Digga offers a range of tractor post hole digger solutions including front mounted auger drives and rear mounted 3 point linkage, PTO and hydraulic driven post hole diggers (ramdrills). Digga has been designing and manufacturing post hole diggers in Australia for over 30 years.
How big is a Ford post hole digger?
3-Pt Post Hole Digger, 540 PTO, Category 2 3-Point Hitch, 8″ Auger Diameter, Approximately 54″ Auger Length, Note: Operational Condition Of This Item Has Not Been Verified And Is Not Disputable By The Buyer. Pote… Ford 903 Post Hole Digger, 540 PTO, Includes 2 Augers, 9” And 12”, Hand Align Lever, SN: 17535
Are there rear mounted post diggers for tractors?
3pt linkage rear mounted post hole diggers for tractors are available in 25hp, 50hp and 75hp. Non-3pt linkage PTO models are also available for tractors with 50hp and 75hp, and PHD hydraulic models for tractors with 45-115lpm hydraulic flow.