What is Nxl mode paintball?
NXL = Full auto pretty much full auto. Millennium = psp3 except you must maintain a certain bps to keep shooting at capped bps. example: shot shot shot maintain 5bps to shoot at 10bps. Once you stop maintaining 5bps, you need to trigger the 3 semi shots before you can ramp.
What is PSP firing mode in paintball?
Semi-Auto/NPPL – One shot per trigger pull. Ramping/PSP – The MINI will operate in semi-auto mode for the first 3 shots then the MINI will ramp to the Rate-of-Fire value in which is defaulted to 13 shots per second for this mode.
What is PSP burst mode for?
Different versions of the PSP mode were devised to enhance the rate of fire in different ways, but the official PSP mode was based on the use of 3 round bursts on each trigger pull to enhance the rate of fire.
How many balls per second can a paintball gun shoot?
In general, a paintball gun can fire as fast as you can pull the trigger. Some paintball guns have long, hard trigger pulls that the effective rate of fire is about 5-6 shots per second. Other paintball guns are fired with circuit boards and can fire up to 30 or more times per second.
What is debounce mode?
It essentially causes each initial closing of the switch to ‘latch’ the switch on for a small amount of time so that the bounces aren’t registered. This can be achieved with physical components on the circuit board or through software on the board’s microcontroller.
What PSI should my paintball gun be?
High-pressure air, compressed air or nitrogen, is stored in the tank at a very high pressure, typically 21,000–31,000 kPa (3,000–4,500 psi). Output is controlled with an attached regulator, regulating the pressure between 1,700 kPa (250 psi) and 5,900 kPa (860 psi), depending on the type of tank.
What should you know before using a paintball gun?
– Read and understand all cautions, warnings, and operating manuals before using any paintball gun or paintball gun accessory. – Do not aim paintball gun at eyes or head of people or at animals. – Paintball guns are to be used with Paintballs only. – To prevent fire or shock hazard, do not expose unit to rain or moisture.
How do you adjust the velocity on a paintball gun?
Shoot the RIZE™ over a chronograph to check the velocity. If adjustment is needed, adjust the velocity by turning the Hyper3™ velocity adjustment screw with a 3/16” Allen key. In (clockwise) will reduce the velocity and out (counter clockwise) will increase the velocity.
How to install a 9v battery on a paintball gun?
A. Remove three right hand side grip panel screws with a 3/32” Allen key. B. Open grip panel and install 9V battery into the connector inside the frame. Start by inserting the top of the battery into the recess and aligning the battery terminals with the contacts on the board, then pushing the bottom of the battery fully into place.
How do you remove a battery from paintball?
Start by inserting the top of the battery into the recess and aligning the battery terminals with the contacts on the board, then pushing the bottom of the battery fully into place. Ensure that the battery removal ribbon leaves a small tail accessible from under battery when installed to aid for easy battery removal.