What is MFI relay?
The Eclipse MFI relay is a four pin relay found in the A-21x section of your Mitsubishi 3.0 liter engine bay fuse box. This part is primarily responsible for powering your fuel pump and enabling your Mitsubishi Eclipse to start.
Where is the ASD relay located in the engine?
kudran, yes it can. The ASD relay is located in the Integrated Power Module (IPM), in the engine compartment. Refer to label on PDC cover for relay location. To test the relay see if this helps. When the PCM energizes the ASD and fuel pump relays, terminal 87 connects to terminal 30. This is the On position.
What are the symptoms of a bad ASD relay?
One of the most common symptoms of a bad (ASD) relay is an engine that will start. But, Stalls almost immediately, or at random times. The (ASD) relay supplies power to the vehicle’s ignition coils and fuel injectors.
Can a fuel pump relay pass the ASD test?
If the relay passed the tests, it operates properly. Check the remainder of the ASD and fuel pump relay circuits. You may be going down a very deep rabbit hole. Remember that Chrysler had incredible trouble, including multiple lawsuits and recall’s based on TIPM issues.
How do you connect a ASD relay terminal 85?
(5) Connect one end of a jumper wire (16 gauge or smaller) to relay terminal 85. Connect the other end of the jumper wire to the ground side of a 12 volt power source. (6) Connect one end of another jumper wire (16 gauge or smaller) to the power side of the 12 volt power source.
kudran, yes it can. The ASD relay is located in the Integrated Power Module (IPM), in the engine compartment. Refer to label on PDC cover for relay location. To test the relay see if this helps. When the PCM energizes the ASD and fuel pump relays, terminal 87 connects to terminal 30. This is the On position.
If the relay passed the tests, it operates properly. Check the remainder of the ASD and fuel pump relay circuits. You may be going down a very deep rabbit hole. Remember that Chrysler had incredible trouble, including multiple lawsuits and recall’s based on TIPM issues.
What happens when the ASD relay is deactivated?
The (ASD) relay will be shut-down; meaning the 12-volt power supply to the (ASD) relay will be deactivated by the (PCM); if the ignition key is left in the ON position. But, Only if the engine has not been running for approximately 1.8 seconds. So, Basically, The (ASD) relay is responsible for supplying switched 12-volt power to the vehicle’s:
(5) Connect one end of a jumper wire (16 gauge or smaller) to relay terminal 85. Connect the other end of the jumper wire to the ground side of a 12 volt power source. (6) Connect one end of another jumper wire (16 gauge or smaller) to the power side of the 12 volt power source.
Two relays. One powers the fuel pump. The other power to various things – Volume Air Fow, Idle Speed Control Motor, EGR solenoid, Evap Purge, Camshaft & Crankshaft sensor. MFI = Multiport Fuel Injection. Get In, Sit Down, Shut Up and HOLD ON.