What is DTC P0011?
What the P0011 code means. P0011 is the OBD-II generic code indicating the engine control module (ECM) has determined that the bank 1 intake camshaft is more advanced than what the ECM has commanded it be. This over-advanced condition could be during advancing or retarding of the camshaft timing.
What causes the p0011 code on a Nissan?
Tech notes Since the Intake valve timing control solenoid valve uses oil flow to control timing, dirty oil can cause the valve to stuck open or close. When there is a gap between angle of target and phase-control angle degree, the valve will stop working and the ECM will trigger the P0011 code.
What does trouble code p0011 mean on an ECM?
The camshaft (s) is (are) adjusted by the ECM through the use of an oil control valve (s) (OCV) also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be. What Are The Symptoms Of Code P0011? What Is The Cause Of Code P0011?
What does p0011 stand for in Bank One?
For example, VVT changes the fuel-air mixture in the engine by opening the cylinder valves for variable amounts of time. This can result in more fuel efficiency or more power as needed. While problems with these systems can set several different codes, P0011 refers to the “A” camshaft in bank one.
What does p0011 code mean on oil life reset?
Press the “INFORMATION” button to scroll through until “OIL LIFE RESET” is displayed. Press and hold “RESET” button until “ACKNOWLEDGED” is displayed. Turn the ignition off. and had P0011 code we replaced cam shaft sensor it went away for a day and engine light came back again. Any suggestions please?
What does the p0011 code stand for in Nissan?
A P0011 code refers to the VVT (variable valve timing) or VCT (variable camshaft timing) components and the car’s PCM (powertrain control module) or ECM (engine control module). VVT is a technology used in the engine to allow it to get greater power or efficiency at different running points.
The camshaft (s) is (are) adjusted by the ECM through the use of an oil control valve (s) (OCV) also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be. What Are The Symptoms Of Code P0011? What Is The Cause Of Code P0011?
What does the p0011 DTC on an Impala mean?
That consists of a few different components but the P0011 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is above a set limit (over-advanced), the engine light will be illluminated and the code will be set. The “A” camshaft is either the intake, left, or front camshaft.
What to do if your check engine light says p0011?
Check to see if there are any other codes along with P0011 and clear your Check Engine Light with FIXD. Check the engine oil level and condition. If it’s low, adjust to spec and test drive to see if the concern is resolved. If it’s dirty, change the oil and filter and test drive to see if the concern is resolved.