What is an aftermarket catalytic converter?
An aftermarket converter is any catalytic converter that is not identical to the new original equipment converter that was on a vehicle when it left the manufacturer.
What happens when the injectors fail on a Chevy EcoTec3?
When the injectors fail, they can fail completely open or stuck closed which can cause serious fueling problems. The end result will be extremely poor engine performance, misfires, jumpy acceleration, engine noise, etc. The engine mounts are known to go bad more frequently than engine mounts should.
Are there any problems with the GM 2.4 Ecotec engine?
A few symptoms of timing chain problems on the GM 2.4 Ecotec engine include: 1 Engine fault codes 2 Rattling sounds 3 Misfires 4 Poor operation More …
What should I do if my engine check light is still coming on?
Put the keys in your ignition and turn your ignition on and off consecutively after a second in each step. Once it is done, see if the engine check light is still coming on or not. If the check light is off, you are ready to go, but if it is still coming on, get ready by reading the codes with a scanner instead.
Can a 2.4L Ecotec engine have an oil leak?
The 2.4L Ecotec can run into oil leaks at any point, but it’s not really common until 10+ years and 100,000+ miles. As such, we don’t really think its fair to chalk it up as a true problem. It’s something to be aware of, though. This is especially true for those looking to buy or own an older, higher mileage 2.4L Ecotec GM engine.
How to get rid of check engine light error?
Then put your key into the ignition and turn it three times to the “ON” position. This will clear the emissions data from the vehicle memory as well as the readiness flag data. Reconnect the positive battery cable and turn the key in the vehicle ignition. Wait one minute and the check engine light error should be gone. 4. Use an OBD Code Reader
Where to plug in the Check Engine light?
Plug the reader into the OBD port of your vehicle. This port is usually located on the underside of the dash area just above the foot well. On some vehicles, you’ll have to remove the door on your fuse box to access this port. Once you have connected the reader, press the “enter” button to turn it on.
How long does it take for check engine light to go off?
If you are sure you have fixed the problem, it takes around 10-30 successful cycles before the check engine light disappears. One process is one cold-start until the engine is warm. Will the check engine light go off by itself? Yes, The check engine light will reset itself after a fixed amount of time if you fixed the problem in most car models.
How can I Cross Check my Check Engine?
Once you have connected the reader, press the “enter” button to turn it on. The device will scan your engine for any error codes. Once done analyzing, the reader will display any error codes it finds. Make note of the codes (if any) if you wish to cross check them in the code reader’s manual or online.