What is a P0877 code?
P0877 is a diagnostic trouble code (DTC) for “Transmission Fluid Pressure Sensor/Switch “D” Circuit Low”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What are the symptoms of a p0872 engine code?
Symptoms of a P0872 engine code may include: Vehicle starts off in 2nd or 3rd gear (limp in mode) Typically the causes for this code to set are: Short to ground in the signal circuit to the TFPS sensor – possible Failed TFPS Sensor / internally shorted – likely
What does the p0989 OBD-II trouble code mean?
What the P0989 code means. The P0989 code is a generic OBD-II trouble code that detects a transmission fluid pressure sensor E circuit abnormality.
What does the p0877 code on a PCM mean?
A P0877 code is registered when the powertrain control module (PCM) is registering transmission fluid pressure that is above or below factory spec. What the P0877 code means The PCM receives information on transmission fluid pressure from a fluid pressure sensor.
What is the p0877 code for transmission fluid pressure?
P0877 code definition. A P0877 code is registered when the powertrain control module (PCM) is registering transmission fluid pressure that is above or below factory spec.
What causes a p0989 trouble code on a transmission?
Potential causes of the P0989 trouble code include: Defective transmission fluid pressure sensor Malfunctioning electronic pressure control solenoid Defective electrical components, such as wires, connectors, and fuses Insufficient transmission fluid levels Dirty transmission fluid Blockages within the hydraulic pressure system
When do I get a p0877 code?
All our repairs are backed by our 12-month / 12,000-mile warranty. A P0877 code is registered when the powertrain control module (PCM) is registering transmission fluid pressure that is above or below factory spec. The PCM receives information on transmission fluid pressure from a fluid pressure sensor.
What does p0872 mean on a pressure switch?
Pressure switch E, usualy means a stuck E shift valve. P0872 has shown that in most cases trucks that set this code have had a cracked transmission adapter housing. Bulletin 03-07-30-031 contains details on the adapter housing repair.
When to replace a p0872 transmission fluid pressure sensor?
If the ohmmeter readings do not pass, replace the TFPS. If all prior tests have passed and you continue to get a P0872, this would most likely indicate a failed TFPS sensor, although a failed PCM/TCM could not be ruled out, nor could internal transmission malfunctions until the TFPS sensor had been replaced.