What is a governor limiter?
A governor, or speed limiter or controller, is a device used to measure and regulate the speed of a machine, such as an engine.
How big is a carburetor restrictor plate hole?
Carburetor Restrictor Plate, Governor Plate Type, Aluminum, 0.5 in. Thick, 4-Barrel Square Bore, 4-hole, Each Carburetor Restrictor Plate, Governor Plate Type, Aluminum, 1 in. Thick, 4-Barrel Square Bore, 4-hole, Each
What is the governor on a Honda variator?
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place.
How to remove the governor for a 50cc Honda Metro scooter?
Removing the governor of your 50 cc Honda Metro scooter will certainly increase its speed, and it may even enable it to travel fast enough that you may need to reregister the vehicle as a larger class motorcycle. Pull out the pin attaching the kickstart to the variator case of your Honda Metro.
Why does a Honda Scooter have a rev limiter?
The purpose of a rev limiter is to prevent a relatively small engine from burning out too quickly as well as to limit the top speed of scooters, preventing them from being classed as larger motorcycles. Your scooter’s rev limiter prevents its engine from transferring all of its energy to the drive belt.
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place.
Removing the governor of your 50 cc Honda Metro scooter will certainly increase its speed, and it may even enable it to travel fast enough that you may need to reregister the vehicle as a larger class motorcycle. Pull out the pin attaching the kickstart to the variator case of your Honda Metro.
The purpose of a rev limiter is to prevent a relatively small engine from burning out too quickly as well as to limit the top speed of scooters, preventing them from being classed as larger motorcycles. Your scooter’s rev limiter prevents its engine from transferring all of its energy to the drive belt.
How do you take the kickstand off a Honda variator?
The kickstand is secured with a small pin that must be loosened with a socket wrench before you can pull it out and remove the kickstand. Unscrew the six bolts holding the metal lid of your variator case in place and take the lid off of your scooter.